8 material differences · fewer than 12
Tractor oneSOMECA 450 (DT)1968–1971No measured PTO figureTractor twoSOMECA SOM-481/T1964–1965No measured PTO figure
Which should you choose?
Read our verdict on the 450 (DT) and the SOM-481/T → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 450 (DT) | SOM-481/T | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 40.5 hp | 40.5 hp | — |
| Engine declared | O.M.-FIAT 8035.01.200 or 300 | O.M.-FIAT 615.130 | differs |
| Displacement declared | 2.34 L | 2.27 L | — |
| Maximum torque declared | 105 lb·ft · 143 N·m | 101 lb·ft · 137 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal operated dry FEREDO double clutch type 10 inch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 21.8 L/min | 4.4 gpm · 16.5 L/min | +32% 450 (DT) |
| Pressure declared | 2,843 psi · 196 bar | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,836 lb · 1,740 kg | 3,086 lb · 1,400 kg | +24% 450 (DT) |
| Wheelbase declared | 75.6 in · 1,920 mm | 82.3 in · 2,090 mm | +9% SOM-481/T |
| Length declared | 122.0 in · 3,100 mm | 122.4 in · 3,110 mm | — |
| Width declared | 59.8–87.4 in · 1,520–2,220 mm | 67.3 in · 1,710 mm | differs |
| Ground clearance declared | 14.2 in · 360 mm | 25.6 in · 650 mm | +81% SOM-481/T |
| Turning radius, braked declared | 9.4 ft · 2.86 m | 8.7 ft · 2.65 m | +8% 450 (DT) |
| Fuel tank declared | 57.1 qt · 54.0 L | 41.2 qt · 39.0 L | +38% 450 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SOMECA 450 (DT) sources
- Source: Traktorenlexikon, “Someca 450”
SOMECA SOM-481/T sources
- Source: Traktorenlexikon, “Someca SOM 481/T”