SOMECA 415 (DT) or ZETOR 4011?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 415 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 4011 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The ZETOR 4011 suits loader and hydraulic implement work better on this data: 28% (5.0 L/min / 1.3 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for SOMECA 415 (DT) and ZETOR 4011, with the call on each
Question415 (DT)4011Call
Which puts more power through the PTO shaft?33.1 kW (44.4 hp)Traktorenlexikon, “Someca 415”33.1 kW (44.4 hp)Traktorenlexikon, “Zetor 4011”Not comparableNot comparable on power at the PTO shaft: the 415 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 4011 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 415 (DT) and the 4011.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 415 (DT) and the 4011.
Which pumps more oil for implements?18.0 L/min (4.8 gpm)Traktorenlexikon, “Someca 415”23.0 L/min (6.1 gpm)Traktorenlexikon, “Zetor 4011”AheadThe ZETOR 4011 has 28% more hydraulic flow (5.0 L/min / 1.3 gpm) than the SOMECA 415 (DT) (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?1,200 kg (2,646 lb)Traktorenlexikon, “Zetor 4011”No figureNo call on three-point lift: no figure on record for the 415 (DT).
Which is heavier, for traction?1,590 kg (3,505 lb)Traktorenlexikon, “Someca 415”1,965 kg (4,332 lb)Traktorenlexikon, “Zetor 4011”Ahead (a fact, not an advantage)The ZETOR 4011 is 24% heavier (375 kg / 827 lb) than the SOMECA 415 (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 415 (DT) and the 4011.
Which has the wider choice of gears?6 to 9Traktorenlexikon, “Someca 415”10Traktorenlexikon, “Zetor 4011”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 415 (DT) and the 4011.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Someca 415”25 km/h (15.5 mph)Traktorenlexikon, “Zetor 4011”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Someca 415”540 rpmTraktorenlexikon, “Zetor 4011”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?No figureNo call on PTO independence: not stated for the 415 (DT) and the 4011.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Someca 415”2WDTraktorenlexikon, “Zetor 4011”AheadThe SOMECA 415 (DT) is available with four-wheel drive; the ZETOR 4011 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1965–19681962–1967EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The ZETOR 4011 has 28% more hydraulic flow (5.0 L/min / 1.3 gpm) than the SOMECA 415 (DT) (both pump flow, as stated by the source).
  • The ZETOR 4011 is 24% heavier (375 kg / 827 lb) than the SOMECA 415 (DT) (both unladen weight, as stated by the source).
  • The SOMECA 415 (DT) is available with four-wheel drive; the ZETOR 4011 is two-wheel drive (as stated by the sources).
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 415 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 4011 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources