10 material differences · fewer than 12
Tractor oneSOMECA 415 (DT)1965–1968No measured PTO figureTractor twoWARCHALOWSKI-MC CORMICK WT-45 A1968–1970No measured PTO figure
Which should you choose?
Read our verdict on the 415 (DT) and the WT-45 A → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 415 (DT) | WT-45 A | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.4 hp | 44.4 hp | — |
| Engine declared | O.M.-FIAT 615.000 | INTERNATIONAL HARVESTER BD-154 | differs |
| Displacement declared | 2.27 L | 2.52 L | +11% WT-45 A |
| Maximum torque declared | 101 lb·ft · 137 N·m | 124 lb·ft · 168 N·m | +23% WT-45 A |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% WT-45 A |
| Clutch declared | Pedal operated dry double clutch | Pedal-operated, two-stage dry Fichtel & Sachs double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 4.8 gpm · 18.0 L/min | — | — |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,505 lb · 1,590 kg | 4,299 lb · 1,950 kg | +23% WT-45 A |
| Wheelbase declared | 75.8 in · 1,925 mm | 79.3 in · 2,015 mm | — |
| Length declared | 119.7 in · 3,040 mm | 131.9 in · 3,350 mm | +10% WT-45 A |
| Width declared | 64.0–90.6 in · 1,625–2,300 mm | 61.0 in · 1,550 mm | differs |
| Ground clearance declared | 18.9 in · 480 mm | 15.4 in · 390 mm | +23% 415 (DT) |
| Turning radius, braked declared | 10.4 ft · 3.18 m | — | — |
| Fuel tank declared | 51.8 qt · 49.0 L | 43.3 qt · 41.0 L | +20% 415 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SOMECA 415 (DT) sources
- Source: Traktorenlexikon, “Someca 415”
- Source: Traktorenlexikon, “Someca SOM 35”
WARCHALOWSKI-MC CORMICK WT-45 A sources
- Source: Traktorenlexikon, “Warchalowski WT 45 A”
- Source: Traktorenlexikon, “McCormick B-414”