11 material differences · fewer than 12
Tractor oneSOMECA 415 (DT)1965–1968No measured PTO figureTractor twoSOMECA SOM-40 Super1963–1964No measured PTO figure
Which should you choose?
Read our verdict on the 415 (DT) and the SOM-40 Super → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 415 (DT) | SOM-40 Super | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.4 hp | 44.4 hp | — |
| Engine declared | O.M.-FIAT 615.000 | O.M.-FIAT CO 2D-45 | differs |
| Displacement declared | 2.27 L | 4.40 L | +94% SOM-40 Super |
| Maximum torque declared | 101 lb·ft · 137 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 13.7 mph · 22 km/h | +14% 415 (DT) |
| Clutch declared | Pedal operated dry double clutch | Pedal operated dry FERODO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 4.8 gpm · 18.0 L/min | 4.0 gpm · 15.2 L/min | +18% 415 (DT) |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,505 lb · 1,590 kg | 5,567 lb · 2,525 kg | +59% SOM-40 Super |
| Wheelbase declared | 75.8 in · 1,925 mm | 80.0 in · 2,032 mm | +6% SOM-40 Super |
| Length declared | 119.7 in · 3,040 mm | 132.5 in · 3,365 mm | +11% SOM-40 Super |
| Width declared | 64.0–90.6 in · 1,625–2,300 mm | 68.7–95.1 in · 1,745–2,415 mm | differs |
| Ground clearance declared | 18.9 in · 480 mm | 14.3 in · 364 mm | +32% 415 (DT) |
| Turning radius, braked declared | 10.4 ft · 3.18 m | 10.8 ft · 3.30 m | — |
| Fuel tank declared | 51.8 qt · 49.0 L | 59.2 qt · 56.0 L | +14% SOM-40 Super |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SOMECA 415 (DT) sources
- Source: Traktorenlexikon, “Someca 415”
- Source: Traktorenlexikon, “Someca SOM 35”
SOMECA SOM-40 Super sources
- Source: Traktorenlexikon, “Someca SOM 40 Super”