SAME Sirenetta (DT) or UTB 302 Dtce-IF?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the Sirenetta (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 302 Dtce-IF has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The UTB 302 Dtce-IF suits loader and hydraulic implement work better on this data: 178% (16.0 L/min / 4.2 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for SAME Sirenetta (DT) and UTB 302 Dtce-IF, with the call on each
QuestionSirenetta (DT)302 Dtce-IFCall
Which puts more power through the PTO shaft?22.1 kW (29.6 hp)Traktorenlexikon, “SAME Sirenetta”22.1 kW (29.6 hp)Traktorenlexikon, “UTB U 302 DTCE IF”Not comparableNot comparable on power at the PTO shaft: the Sirenetta (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 302 Dtce-IF has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the Sirenetta (DT) and the 302 Dtce-IF.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the Sirenetta (DT) and the 302 Dtce-IF.
Which pumps more oil for implements?9.0 L/min (2.4 gpm)Traktorenlexikon, “SAME Sirenetta”25.0 L/min (6.6 gpm)Traktorenlexikon, “UTB U 302 DTCE IF”AheadThe UTB 302 Dtce-IF has 178% more hydraulic flow (16.0 L/min / 4.2 gpm) than the SAME Sirenetta (DT) (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?950 kg (2,094 lb)Traktorenlexikon, “SAME Sirenetta”1,200 kg (2,646 lb)Traktorenlexikon, “UTB U 302 DTCE IF”Not comparableNot comparable on three-point lift: the Sirenetta (DT): lift at an unstated point, as stated by the source (Traktorenlexikon, “SAME Sirenetta”); the 302 Dtce-IF: lift at the hitch ends, as stated by the source (Traktorenlexikon, “UTB U 302 DTCE IF”) — not the same quantity, basis and condition.
Which is heavier, for traction?1,380 kg (3,042 lb)Traktorenlexikon, “SAME Sirenetta”2,775 kg (6,118 lb)Traktorenlexikon, “UTB U 302 DTCE IF”Ahead (a fact, not an advantage)The UTB 302 Dtce-IF is 101% heavier (1,395 kg / 3,075 lb) than the SAME Sirenetta (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the Sirenetta (DT) and the 302 Dtce-IF.
Which has the wider choice of gears?6 to 12Traktorenlexikon, “SAME Sirenetta”6Traktorenlexikon, “UTB U 302 DTCE IF”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the Sirenetta (DT) and the 302 Dtce-IF.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “SAME Sirenetta”25 km/h (15.5 mph)Traktorenlexikon, “UTB U 302 DTCE IF”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “SAME Sirenetta”540 rpmTraktorenlexikon, “UTB U 302 DTCE IF”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?dependent (stops with the clutch)Traktorenlexikon, “SAME Sirenetta”No figureNo call on PTO independence: not stated for the 302 Dtce-IF.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “SAME Sirenetta”4WDTraktorenlexikon, “UTB U 302 DTCE IF”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1971–19721980–1991Ahead (a fact, not an advantage)The UTB 302 Dtce-IF is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The UTB 302 Dtce-IF has 178% more hydraulic flow (16.0 L/min / 4.2 gpm) than the SAME Sirenetta (DT) (both pump flow, as stated by the source).
  • The UTB 302 Dtce-IF is 101% heavier (1,395 kg / 3,075 lb) than the SAME Sirenetta (DT) (both unladen weight, as stated by the source).
  • The UTB 302 Dtce-IF is newer: production began 9 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the Sirenetta (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 302 Dtce-IF has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • Not comparable on three-point lift: the Sirenetta (DT): lift at an unstated point, as stated by the source (Traktorenlexikon, “SAME Sirenetta”); the 302 Dtce-IF: lift at the hitch ends, as stated by the source (Traktorenlexikon, “UTB U 302 DTCE IF”) — not the same quantity, basis and condition.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources