5 material differences · fewer than 12
Tractor oneSAME Panter (DT)1973–1977No measured PTO figureTractor twoSAME Panther 90 (DT)1978–1980No measured PTO figure
Which should you choose?
Read our verdict on the Panter (DT) and the Panther 90 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | Panter (DT) | Panther 90 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 82 hp | 88.8 hp | +9% Panther 90 (DT) |
| Engine declared | SAME DA 985 P | SAME DA 985 P | — |
| Displacement declared | 4.52 L | 4.52 L | — |
| Maximum torque declared | 203 lb·ft · 275 N·m | 207 lb·ft · 280 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | — | Pedal-operated dry Borg & Beck single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 8.4 gpm · 31.7 L/min | 8.4 gpm · 31.7 L/min | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,033 lb · 3,190 kg | 8,157 lb · 3,700 kg | +16% Panther 90 (DT) |
| Wheelbase declared | 98.4 in · 2,499 mm | 98.4 in · 2,499 mm | — |
| Length declared | 161.4 in · 4,100 mm | — | — |
| Width declared | 76.0–79.9 in · 1,930–2,030 mm | 83.1–102.8 in · 2,112–2,612 mm | differs |
| Ground clearance declared | 23.6 in · 600 mm | 19.7 in · 500 mm | +20% Panter (DT) |
| Turning radius, braked declared | 10.8 ft · 3.30 m | 12.5 ft · 3.80 m | +15% Panther 90 (DT) |
| Fuel tank declared | 95.1 qt · 90.0 L | 101.4 qt · 96.0 L | +7% Panther 90 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SAME Panter (DT) sources
- Source: Traktorenlexikon, “SAME Panther”
SAME Panther 90 (DT) sources
- Source: Traktorenlexikon, “SAME Panther 90”
- Source: Traktorenlexikon, “SAME Panther”