10 material differences · fewer than 12
Tractor oneSAME Falcon 501974–1987No measured PTO figureTractor twoURSUS C-3601976–1994No measured PTO figure
Which should you choose?
Read our verdict on the Falcon 50 and the C-360 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Falcon 50 | C-360 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 49.3 hp | 51.2 hp | — |
| Engine declared | SAME DA 03544-983 L | URSUS/ZM S-4003 | differs |
| Displacement declared | 2.72 L | 3.12 L | +15% C-360 |
| Maximum torque declared | 125 lb·ft · 170 N·m | 140 lb·ft · 190 N·m | +12% C-360 |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal operated dry two stage double clutch with coil springs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.8 gpm · 18.0 L/min | 6.9 gpm · 26.3 L/min | +46% C-360 |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,365 lb · 1,980 kg | 4,784 lb · 2,170 kg | +10% C-360 |
| Maximum permissible mass declared | 7,606 lb · 3,450 kg | — | — |
| Wheelbase declared | 73.2 in · 1,860 mm | 83.7 in · 2,125 mm | +14% C-360 |
| Length declared | 125.2 in · 3,180 mm | 140.6 in · 3,571 mm | +12% C-360 |
| Width declared | 73.2 in · 1,860 mm | 70.9 in · 1,800 mm | — |
| Ground clearance declared | 14.2 in · 360 mm | 15.6 in · 395 mm | +10% C-360 |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 11.1 ft · 3.37 m | +7% C-360 |
| Fuel tank declared | 47.6 qt · 45.0 L | 74.0 qt · 70.0 L | +56% C-360 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SAME Falcon 50 sources
- Source: Traktorenlexikon, “SAME Falcon 50”
URSUS C-360 sources
- Source: Traktorenlexikon, “Ursus C-360”