Renault 85-12 TX or VALMET 605/605-4?
Which should you choose?
On performance, every comparable figure that differs favours the VALMET 605/605-4: hydraulic flow. It is also ahead on drive.
- The VALMET 605/605-4 suits loader and hydraulic implement work better on this data: 27% (11.3 L/min / 3.0 gpm) more hydraulic flow.
- The VALMET 605/605-4 suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 85-12 TX | 605/605-4 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 48.0 kW (64.4 hp)Traktorenlexikon, “Renault 85-12 TS/TX R7761” | 48.2 kW (64.6 hp)Traktorenlexikon, “Valmet 605” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 85-12 TX and the 605/605-4. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 85-12 TX and the 605/605-4. |
| Which pumps more oil for implements? | 41.4 L/min (10.9 gpm)Traktorenlexikon, “Renault 85-12 TS/TX R7761” | 52.7 L/min (13.9 gpm)Traktorenlexikon, “Valmet 605” | AheadThe VALMET 605/605-4 has 27% more hydraulic flow (11.3 L/min / 3.0 gpm) than the Renault 85-12 TX (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 3,825 kg (8,433 lb)Traktorenlexikon, “Renault 85-12 TS/TX R7761” | 3,946 kg (8,699 lb)Traktorenlexikon, “Valmet 605” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 3,405 kg (7,507 lb)Traktorenlexikon, “Renault 85-12 TS/TX R7761” | 3,440 kg (7,584 lb)Traktorenlexikon, “Valmet 605” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 85-12 TX and the 605/605-4. |
| Which has the wider choice of gears? | 12 to 24Traktorenlexikon, “Renault 85-12 TS/TX R7761” | 8 to 16Traktorenlexikon, “Valmet 605” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 85-12 TX and the 605/605-4. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Renault 85-12 TS/TX R7761” | 30 km/h (18.6 mph)Traktorenlexikon, “Valmet 605” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Renault 85-12 TS/TX R7761” | 540/1000 rpmTraktorenlexikon, “Valmet 605” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | independentTraktorenlexikon, “Valmet 605” | No figureNo call on PTO independence: not stated for the 85-12 TX. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Renault 85-12 TS/TX R7761” | 2WD / 4WDTraktorenlexikon, “Valmet 605” | AheadThe VALMET 605/605-4 is available with four-wheel drive; the Renault 85-12 TX is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1986–1989 | 1983–1989 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The VALMET 605/605-4 has 27% more hydraulic flow (11.3 L/min / 3.0 gpm) than the Renault 85-12 TX (both pump flow, as stated by the source).
- The VALMET 605/605-4 is available with four-wheel drive; the Renault 85-12 TX is two-wheel drive (as stated by the sources).
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources