11 material differences · fewer than 12
Tractor oneRenault 751-41973–1980No measured PTO figureTractor twoSOMECA 750 (TD)1971–1976No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 751-4 | 750 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74.0 hp | 74.0 hp | — |
| Engine declared | MWM D 226-4 | O.M.-FIAT CO 3/70 | differs |
| Displacement declared | 4.15 L | 4.56 L | +10% 750 (TD) |
| Maximum torque declared | 188 lb·ft · 255 N·m | 206 lb·ft · 279 N·m | +9% 750 (TD) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 14.9 mph · 24 km/h | — |
| Clutch declared | Dry LuK double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 8.7 gpm · 33.0 L/min | 7.3 gpm · 27.5 L/min | +20% 751-4 |
| Pressure declared | 2,321 psi · 160 bar | — | — |
| Three-point lift, at the coupling points declared | 6,063 lb · 2,750 kg | 4,960 lb · 2,250 kg | +22% 751-4 |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,529 lb · 3,415 kg | 6,713 lb · 3,045 kg | +12% 751-4 |
| Wheelbase declared | 95.7 in · 2,430 mm | 96.1 in · 2,440 mm | — |
| Length declared | 162.6 in · 4,130 mm | 153.9 in · 3,910 mm | +6% 751-4 |
| Width declared | 76.4–97.6 in · 1,940–2,480 mm | 72.0 in · 1,830 mm | differs |
| Ground clearance declared | 15.4 in · 390 mm | 20.5 in · 520 mm | +33% 750 (TD) |
| Turning radius, braked declared | 16.6 ft · 5.05 m | 12.5 ft · 3.80 m | +33% 751-4 |
| Fuel tank declared | 86.6 qt · 82.0 L | 85.6 qt · 81.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Renault 751-4 sources
- Source: Traktorenlexikon, “Renault 751-4 R7624”
- Source: Traktorenlexikon, “Fendt Farmer 108 S/SA”
- Source: Traktorenlexikon, “Renault 751-4S R7504”
SOMECA 750 (TD) sources
- Source: Traktorenlexikon, “Someca 750”