Renault 70-32 PX or Renault Ceres 325?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 70-32 PX: power at the PTO, claimed (Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”); the Ceres 325: power at the PTO, measured by a laboratory at maximum power (OECD Test 1968) — not the same quantity, basis and condition.

  • The Renault Ceres 325 suits loader and hydraulic implement work better on this data: 56% (18.0 L/min / 4.8 gpm) more hydraulic flow.
  • The Renault Ceres 325 suits heavy draft work (ploughing, cultivating) better on this data: 21% (620 kg / 1,367 lb) heavier and four-wheel drive.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Renault 70-32 PX and Renault Ceres 325, with the call on each
Question70-32 PXCeres 325Call
Which puts more power through the PTO shaft?45.3 kW (60.7 hp)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”45.3 kW (60.7 hp)OECD Test 1968Not comparableNot comparable on power at the PTO shaft: the 70-32 PX: power at the PTO, claimed (Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”); the Ceres 325: power at the PTO, measured by a laboratory at maximum power (OECD Test 1968) — not the same quantity, basis and condition.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 70-32 PX and the Ceres 325.
Which pulls harder at the drawbar?37.1 kW (49.8 hp)OECD Test 1968No figureNo call on drawbar power: no figure on record for the 70-32 PX.
Which pumps more oil for implements?32.1 L/min (8.5 gpm)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”50.1 L/min (13.2 gpm)Traktorenlexikon, “Renault Ceres 325”AheadThe Renault Ceres 325 has 56% more hydraulic flow (18.0 L/min / 4.8 gpm) than the Renault 70-32 PX (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?2,870 kg (6,327 lb)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”2,870 kg (6,327 lb)Traktorenlexikon, “Renault Ceres 325”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?2,900 kg (6,393 lb)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”3,520 kg (7,760 lb) to 3,655 kg (8,058 lb), varies by configurationTraktorenlexikon, “Renault Ceres 325”Ahead (a fact, not an advantage)The Renault Ceres 325 is 21% heavier (620 kg / 1,367 lb) than the Renault 70-32 PX (both unladen weight, as stated by the source).
Which may carry more ballast and load?5,560 kg (12,258 lb)Traktorenlexikon, “Renault Ceres 325”No figureNo call on maximum permissible mass: no figure on record for the 70-32 PX.
Which has the wider choice of gears?12 to 24Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”20OECD test report 1968, 2001Sources disagreeNo call on forward gears: sources disagree on the figure for the Ceres 325.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 70-32 PX and the Ceres 325.
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Renault Ceres 325”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”540/1000 rpmOECD test report 1979, 2002EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”No figureNo call on PTO independence: not stated for the Ceres 325.
Which drives on both axles?2WDTraktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”4WDOECD test report 1968, 2001; OECD test report 1979, 2002; Traktorenlexikon, “Renault Ceres 325”AheadThe Renault Ceres 325 is available with four-wheel drive; the Renault 70-32 PX is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1989–19922000–2004Ahead (a fact, not an advantage)The Renault Ceres 325 is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Renault Ceres 325 has 56% more hydraulic flow (18.0 L/min / 4.8 gpm) than the Renault 70-32 PX (both pump flow, as stated by the source).
  • The Renault Ceres 325 is 21% heavier (620 kg / 1,367 lb) than the Renault 70-32 PX (both unladen weight, as stated by the source).
  • The Renault Ceres 325 is available with four-wheel drive; the Renault 70-32 PX is two-wheel drive (as stated by the sources).
  • The Renault Ceres 325 is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Not comparable on power at the PTO shaft: the 70-32 PX: power at the PTO, claimed (Traktorenlexikon, “Renault 70-32 PE/PA/PS/PX R3131”); the Ceres 325: power at the PTO, measured by a laboratory at maximum power (OECD Test 1968) — not the same quantity, basis and condition.
  • No call on forward gears: sources disagree on the figure for the Ceres 325.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources