5 material differences · fewer than 12
Tractor oneRenault 4561968–1972No measured PTO figureTractor twoSOMECA 420 (TD)1978–1985No measured PTO figure
Which should you choose?
Read our verdict on the 456 and the 420 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 456 | 420 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 41.4 hp | 41.4 hp | — |
| Engine declared | — | FIAT-IVECO 8035.01.308 | — |
| Displacement declared | — | 2.34 L | — |
| Maximum torque declared | — | 107 lb·ft · 145 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Two-stage pedal-operated dry FERODO double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.5 gpm · 17.0 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Three-point lift, at the coupling points declared | 4,409 lb · 2,000 kg | 2,425 lb · 1,100 kg | +82% 456 |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,409 lb · 2,000 kg | 3,638 lb · 1,650 kg | +21% 456 |
| Wheelbase declared | 76.0 in · 1,930 mm | 74.8 in · 1,900 mm | — |
| Length declared | 129.9 in · 3,300 mm | 113.4 in · 2,880 mm | +15% 456 |
| Width declared | 66.9 in · 1,700 mm | 65.2–81.1 in · 1,657–2,059 mm | differs |
| Ground clearance declared | — | 17.7 in · 450 mm | — |
| Turning radius, braked declared | — | 9.7 ft · 2.95 m | — |
| Fuel tank declared | 58.1 qt · 55.0 L | 38.0 qt · 36.0 L | +53% 456 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Renault 456 sources
- Source: Traktorenlexikon, “Renault 456 R7255”
SOMECA 420 (TD) sources
- Source: Traktorenlexikon, “Someca 420”
- Source: Traktorenlexikon, “Fiat 420/420 DT”