OLIVER 2055 or Steyr 1200 (a)?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level. On features, the Steyr 1200 (a) is ahead on drive.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for OLIVER 2055 and Steyr 1200 (a), with the call on each
Question20551200 (a)Call
Which puts more power through the PTO shaft?77.6 kW (104.1 hp)Traktorenlexikon, “Oliver 2055”76.9 kW (103.2 hp)Traktorenlexikon, “Steyr 1200”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 2055 and the 1200 (a).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 2055 and the 1200 (a).
Which pumps more oil for implements?75.7 L/min (20.0 gpm)Traktorenlexikon, “Oliver 2055”No figureNo call on hydraulic flow: no figure on record for the 1200 (a).
Which lifts more on the three-point hitch?3,800 kg (8,378 lb)Traktorenlexikon, “Steyr 1200”No figureNo call on three-point lift: no figure on record for the 2055.
Which is heavier, for traction?4,842 kg (10,675 lb)Traktorenlexikon, “Oliver 2055”4,036 kg (8,898 lb)Traktorenlexikon, “Steyr 1200”Ahead (a fact, not an advantage)The OLIVER 2055 is 20% heavier (806 kg / 1,777 lb) than the Steyr 1200 (a) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 2055 and the 1200 (a).
Which has the wider choice of gears?10Traktorenlexikon, “Oliver 2055”12 to 16Traktorenlexikon, “Steyr 1200”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 2055 and the 1200 (a).
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Oliver 2055”25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Steyr 1200”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?1000 rpmTraktorenlexikon, “Oliver 2055”1000 rpmTraktorenlexikon, “Steyr 1200”EvenEven on PTO speeds: the same speeds (1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Oliver 2055”independentTraktorenlexikon, “Steyr 1200”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?2WDTraktorenlexikon, “Oliver 2055”2WD / 4WDTraktorenlexikon, “Steyr 1200”AheadThe Steyr 1200 (a) is available with four-wheel drive; the OLIVER 2055 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1969–19711972–1975EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The OLIVER 2055 is 20% heavier (806 kg / 1,777 lb) than the Steyr 1200 (a) (both unladen weight, as stated by the source).
  • The Steyr 1200 (a) is available with four-wheel drive; the OLIVER 2055 is two-wheel drive (as stated by the sources).
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources