New Holland TLA 80 (A) or VALMET 900?
Which should you choose?
On performance, every comparable figure that differs favours the New Holland TLA 80 (A): hydraulic flow. It is also ahead on PTO speeds.
- The New Holland TLA 80 (A) suits PTO-driven implements (mowers, balers, pumps) better on this data: offers 1000 rpm.
- The New Holland TLA 80 (A) suits loader and hydraulic implement work better on this data: 12% (6.7 L/min / 1.8 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | TLA 80 (A) | 900 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 53.9 kW (72.3 hp)Traktorenlexikon, “New Holland TL 80 A (2004-2008)” | 54.0 kW (72.4 hp)Traktorenlexikon, “Valmet 900/II” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the TLA 80 (A) and the 900. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the TLA 80 (A) and the 900. |
| Which pumps more oil for implements? | 62.4 L/min (16.5 gpm)Traktorenlexikon, “New Holland TL 80 A (2004-2008)” | 55.7 L/min (14.7 gpm)Traktorenlexikon, “Valmet 900/II” | AheadThe New Holland TLA 80 (A) has 12% more hydraulic flow (6.7 L/min / 1.8 gpm) than the VALMET 900 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | — | 3,365 kg (7,419 lb)Traktorenlexikon, “Valmet 900/II” | No figureNo call on three-point lift: no figure on record for the TLA 80 (A). |
| Which is heavier, for traction? | 3,840 kg (8,466 lb)Traktorenlexikon, “New Holland TL 80 A (2004-2008)” | 3,360 kg (7,408 lb)Traktorenlexikon, “Valmet 900/II” | Ahead (a fact, not an advantage)The New Holland TLA 80 (A) is 14% heavier (480 kg / 1,058 lb) than the VALMET 900 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 5,500 kg (12,125 lb)Traktorenlexikon, “New Holland TL 80 A (2004-2008)” | — | No figureNo call on maximum permissible mass: no figure on record for the 900. |
| Which has the wider choice of gears? | 12 to 24Traktorenlexikon, “New Holland TL 80 A (2004-2008)” | 8 to 16Traktorenlexikon, “Valmet 900/II” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | YesTraktorenlexikon, “New Holland TL 80 A (2004-2008)” | — | No figureNo call on a creeper range: not stated for the 900. |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “New Holland TL 80 A (2004-2008)” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Valmet 900/II” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/540E/1000 rpmTraktorenlexikon, “New Holland TL 80 A (2004-2008)” | 540E/540 rpmTraktorenlexikon, “Valmet 900/II” | AheadThe New Holland TLA 80 (A) offers 1000 rpm at the PTO, which the VALMET 900 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “New Holland TL 80 A (2004-2008)” | — | No figureNo call on PTO independence: not stated for the 900. |
| Which drives on both axles? | 2WD / 4WDTraktorenlexikon, “New Holland TL 80 A (2004-2008)” | 2WD / 4WDTraktorenlexikon, “Valmet 900/II” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 2004–2008 | 1997–2002 | Ahead (a fact, not an advantage)The New Holland TLA 80 (A) is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The New Holland TLA 80 (A) has 12% more hydraulic flow (6.7 L/min / 1.8 gpm) than the VALMET 900 (both pump flow, as stated by the source).
- The New Holland TLA 80 (A) is 14% heavier (480 kg / 1,058 lb) than the VALMET 900 (both unladen weight, as stated by the source).
- The New Holland TLA 80 (A) offers 1000 rpm at the PTO, which the VALMET 900 does not (as stated by the sources).
- The New Holland TLA 80 (A) is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources