New Holland T 7030 or Steyr 9170 a?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the T 7030 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9170 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for New Holland T 7030 and Steyr 9170 a, with the call on each
QuestionT 70309170 aCall
Which puts more power through the PTO shaft?122.8 kW (164.7 hp)Traktorenlexikon, “New Holland T7030 Power Command”125.1 kW (167.8 hp)Traktorenlexikon, “Steyr 9170”Not comparableNot comparable on power at the PTO shaft: the T 7030 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9170 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the T 7030 and the 9170 a.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the T 7030 and the 9170 a.
Which pumps more oil for implements?121.0 L/min (32.0 gpm)Traktorenlexikon, “New Holland T7030 Power Command”No figureNo call on hydraulic flow: no figure on record for the 9170 a.
Which lifts more on the three-point hitch?8,647 kg (19,063 lb)Traktorenlexikon, “New Holland T7030 Power Command”No figureNo call on three-point lift: no figure on record for the 9170 a.
Which is heavier, for traction?8,115 kg (17,891 lb)Traktorenlexikon, “New Holland T7030 Power Command”6,585 kg (14,517 lb)Traktorenlexikon, “Steyr 9170”Ahead (a fact, not an advantage)The New Holland T 7030 is 23% heavier (1,530 kg / 3,373 lb) than the Steyr 9170 a (both unladen weight, as stated by the source).
Which may carry more ballast and load?12,000 kg (26,455 lb)Traktorenlexikon, “New Holland T7030 Power Command”11,000 kg (24,251 lb)Traktorenlexikon, “Steyr 9170”EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
Which has the wider choice of gears?18 to 19Traktorenlexikon, “New Holland T7030 Power Command”32Traktorenlexikon, “Steyr 9170”AheadThe Steyr 9170 a has 68% more forward gears (13 gears) than the New Holland T 7030 (both forward gears, as stated by the source).
Which offers a creeper range?No figureNo call on a creeper range: not stated for the T 7030 and the 9170 a.
Which is faster on the road?40 km/h (24.9 mph) to 50 km/h (31.1 mph)Traktorenlexikon, “New Holland T7030 Power Command”40 km/h (24.9 mph)Traktorenlexikon, “Steyr 9170”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/540E/1000 rpmTraktorenlexikon, “New Holland T7030 Power Command”540/1000 rpmTraktorenlexikon, “Steyr 9170”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “New Holland T7030 Power Command”No figureNo call on PTO independence: not stated for the 9170 a.
Which drives on both axles?4WDTraktorenlexikon, “New Holland T7030 Power Command”4WDTraktorenlexikon, “Steyr 9170”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?2007–20111993–1995Ahead (a fact, not an advantage)The New Holland T 7030 is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The New Holland T 7030 is 23% heavier (1,530 kg / 3,373 lb) than the Steyr 9170 a (both unladen weight, as stated by the source).
  • The Steyr 9170 a has 68% more forward gears (13 gears) than the New Holland T 7030 (both forward gears, as stated by the source).
  • The New Holland T 7030 is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the T 7030 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9170 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources