8 material differences · fewer than 12
Tractor oneMassey Ferguson MF 371963–1965No measured PTO figureTractor twoSAME Atlanta-V (DT)1965–1968No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | MF 37 | Atlanta-V (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 41.4 hp | 41.4 hp | — |
| Engine declared | Perkins A 3.152 | SAME 954/V | differs |
| Displacement declared | 2.50 L | 3.40 L | +36% Atlanta-V (DT) |
| Maximum torque declared | 116 lb·ft · 158 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal operated dry Laycock single clutch with 279 mm disc diameter | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.2 gpm · 15.9 L/min | 3.2 gpm · 12.0 L/min | +33% MF 37 |
| Pressure declared | 2,304 psi · 159 bar | — | — |
| Rear PTO speeds declared | 1337 | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,179 lb · 1,442 kg | 3,483 lb · 1,580 kg | +10% Atlanta-V (DT) |
| Wheelbase declared | 72.0 in · 1,830 mm | 72.0 in · 1,830 mm | — |
| Length declared | 116.9 in · 2,970 mm | 109.4 in · 2,780 mm | +7% MF 37 |
| Width declared | 63.8 in · 1,620 mm | 58.7 in · 1,490 mm | +9% MF 37 |
| Ground clearance declared | 13.4 in · 340 mm | 16.9 in · 430 mm | +26% Atlanta-V (DT) |
| Turning radius, braked declared | 8.7 ft · 2.66 m | — | — |
| Fuel tank declared | 40.7 qt · 38.5 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Massey Ferguson MF 37 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 37”
- Source: Traktorenlexikon, “Massey Ferguson MF 233”
- Source: Traktorenlexikon, “Massey Ferguson MF 37 S”
SAME Atlanta-V (DT) sources
- Source: Traktorenlexikon, “SAME Atlanta V (DT)”
- Source: Traktorenlexikon, “SAME Atlanta 45 (DT)”