9 material differences · fewer than 12
Tractor oneLandini TL 33 N/A (R 5530 F)1983–1987No measured PTO figureTractor twoSteyr 8055 (a)1981–1992No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | TL 33 N/A (R 5530 F) | 8055 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 47.3 hp | — |
| Engine declared | Perkins AD 3.152 S | 2020 bis 2021 = Motor WD-311.44 | differs |
| Displacement declared | 2.50 L | 2.59 L | — |
| Maximum torque declared | 130 lb·ft · 176 N·m | 147 lb·ft · 199 N·m | +13% 8055 (a) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5–24.9 mph · 25–40 km/h | differs |
| Clutch declared | Dry Luk double clutch | Dry Fichtel and Sachs double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 9.8 gpm · 37.1 L/min | 9.1 gpm · 34.4 L/min | +8% TL 33 N/A (R 5530 F) |
| Pressure declared | — | 3,553 psi · 245 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,200 lb · 1,905 kg | 4,453 lb · 2,020 kg | +6% 8055 (a) |
| Maximum permissible mass declared | — | 7,716 lb · 3,500 kg | — |
| Wheelbase declared | 77.0 in · 1,955 mm | 74.8 in · 1,900 mm | — |
| Length declared | 131.1 in · 3,330 mm | 128.0 in · 3,252 mm | — |
| Width declared | 52.3–73.7 in · 1,328–1,873 mm | 69.1–74.8 in · 1,755–1,900 mm | differs |
| Ground clearance declared | 12.7 in · 323 mm | 16.3 in · 415 mm | +28% 8055 (a) |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 10.6 ft · 3.22 m | — |
| Fuel tank declared | 56.0 qt · 53.0 L | 42.3 qt · 40.0 L | +33% TL 33 N/A (R 5530 F) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Landini TL 33 N/A (R 5530 F) sources
- Source: Traktorenlexikon, “Landini TL 33 NA”
- Source: Traktorenlexikon, “Massey Ferguson MF 255”
Steyr 8055 (a) sources
- Source: Traktorenlexikon, “Steyr 8055”
- Source: Traktorenlexikon, “Steyr 8055 Turbo”