10 material differences · fewer than 12

Tractor oneLandini R-8860 (DT) TL-23 N/M (TL-23 DT/M)1988–2000No measured PTO figureTractor twoSAME Explorer 80 (DT)1986–1990No measured PTO figure

Which should you choose?

Read our verdict on the R-8860 (DT) TL-23 N/M (TL-23 DT/M) and the Explorer 80 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

10 material differences · 7 fields identical or within 5%, which is not counted as material

Landini R-8860 (DT) TL-23 N/M (TL-23 DT/M) and SAME Explorer 80 (DT), field by field
FieldR-8860 (DT) TL-23 N/M (TL-23 DT/M)Explorer 80 (DT)Gap
Engine
Engine power, claimed claimed78.9 hp78.9 hp—
Engine declaredPerkins LF 4.248SAME 1000.4 A 1differs
Displacement declared4.06 L4.00 L—
Maximum torque declared215 lb·ft · 291 N·m193 lb·ft · 261 N·m+11% R-8860 (DT) TL-23 N/M (TL-23 DT/M)
Transmission
Top speed declared18.6 mph · 30 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredDry and air-cooled OMG double clutchPedal-operated dry SAME single-disc clutchdiffers
Hydraulics & hitch
Hydraulic control declared—Load sensing—
Pump flow declared9.3 gpm · 35.3 L/min10.7 gpm · 40.5 L/min+15% Explorer 80 (DT)
Pressure declared2,756 psi · 190 bar1,740 psi · 120 bar+58% R-8860 (DT) TL-23 N/M (TL-23 DT/M)
Three-point lift, at the coupling points declared4,343 lb · 1,970 kg7,606 lb · 3,450 kg+75% Explorer 80 (DT)
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared6,437 lb · 2,920 kg6,614 lb · 3,000 kg—
Wheelbase declared92.2 in · 2,341 mm95.1 in · 2,415 mm—
Length declared150.0 in · 3,810 mm145.2 in · 3,687 mm—
Width declared77.8 in · 1,975 mm73.6–101.2 in · 1,870–2,570 mmdiffers
Ground clearance declared21.3 in · 540 mm20.5 in · 520 mm—
Turning radius, braked declared13.5 ft · 4.11 m9.6 ft · 2.94 m+40% R-8860 (DT) TL-23 N/M (TL-23 DT/M)
Fuel tank declared90.9 qt · 86.0 L105.7 qt · 100.0 L+16% Explorer 80 (DT)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Landini R-8860 (DT) TL-23 N/M (TL-23 DT/M) sources

Source
  • Source: Traktorenlexikon, “Landini 8860”

SAME Explorer 80 (DT) sources

Source
  • Source: Traktorenlexikon, “SAME Explorer 80”