9 material differences · fewer than 12

Tractor oneLandini 8830 (DT) TL-23 N/E (TL-23 DT/F)1983–1987No measured PTO figureTractor twoLandini R-8880 (DT)1987–2000No measured PTO figure

Which should you choose?

Read our verdict on the 8830 (DT) TL-23 N/E (TL-23 DT/F) and the R-8880 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

9 material differences · 6 fields identical or within 5%, which is not counted as material

Landini 8830 (DT) TL-23 N/E (TL-23 DT/F) and Landini R-8880 (DT), field by field
Field8830 (DT) TL-23 N/E (TL-23 DT/F)R-8880 (DT)Gap
Engine
Engine power, claimed claimed78.9 hp78.9 hp—
Engine declaredPerkins A 4.248Perkins LF 4.248differs
Displacement declared4.07 L4.06 L—
Maximum torque declared208 lb·ft · 282 N·m199 lb·ft · 270 N·m—
Transmission
Top speed declared18.6 mph · 30 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredDry and air-cooled OMG double clutch——
Hydraulics & hitch
Pump flow declared9.3 gpm · 35.3 L/min9.7 gpm · 36.7 L/min—
Pressure declared—2,756 psi · 190 bar—
Three-point lift, at the coupling points declared6,614 lb · 3,000 kg8,157 lb · 3,700 kg+23% R-8880 (DT)
Rear PTO speeds declared540/1000 rpm540/540E/1000 rpmdiffers
Weight & dimensions
Unladen weight declared6,217 lb · 2,820 kg7,760 lb · 3,520 kg+25% R-8880 (DT)
Wheelbase declared90.6 in · 2,300 mm96.1 in · 2,440 mm+6% R-8880 (DT)
Length declared151.6 in · 3,850 mm155.5 in · 3,950 mm—
Width declared76.8 in · 1,950 mm82.3 in · 2,090 mm+7% R-8880 (DT)
Ground clearance declared22.0 in · 560 mm18.5 in · 470 mm+19% 8830 (DT) TL-23 N/E (TL-23 DT/F)
Turning radius, braked declared13.0 ft · 3.95 m12.8 ft · 3.89 m—
Fuel tank declared63.9 qt · 60.5 L107.8 qt · 102.0 L+69% R-8880 (DT)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Landini 8830 (DT) TL-23 N/E (TL-23 DT/F) sources

Source
  • Source: Traktorenlexikon, “Landini 8830 (DT)”
  • Source: Traktorenlexikon, “Massey Ferguson MF 178”

Landini R-8880 (DT) sources

Source
  • Source: Traktorenlexikon, “Landini 8880”
  • Source: Traktorenlexikon, “Landini 8860”