6 material differences · fewer than 12
Tractor oneLandini 7800 (DT)1987–2000No measured PTO figureTractor twoSAME Centauro 70 (DT)1981–1987No measured PTO figure
Which should you choose?
Read our verdict on the 7800 (DT) and the Centauro 70 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 7800 (DT) | Centauro 70 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 67 hp | 67 hp | — |
| Engine declared | Perkins LD 4.236 | SAME DA 984 P or DA 1004 P | differs |
| Displacement declared | 3.87 L | — | — |
| Maximum torque declared | 182 lb·ft · 247 N·m | 170 lb·ft · 230 N·m | +7% 7800 (DT) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | pedal-operated dry single-plate clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.9 gpm · 49.0 L/min | 11.2 gpm · 42.5 L/min | +15% 7800 (DT) |
| Pressure declared | 2,901 psi · 200 bar | — | — |
| Three-point lift, at the coupling points declared | 7,848 lb · 3,560 kg | 8,157 lb · 3,700 kg | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,168 lb · 3,705 kg | 6,019 lb · 2,730 kg | +36% 7800 (DT) |
| Wheelbase declared | 93.3 in · 2,371 mm | 92.5 in · 2,350 mm | — |
| Length declared | 155.5 in · 3,950 mm | 151.2 in · 3,840 mm | — |
| Width declared | 78.3 in · 1,990 mm | 76.0–95.7 in · 1,930–2,430 mm | differs |
| Ground clearance declared | — | 16.5 in · 420 mm | — |
| Turning radius, braked declared | — | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 156.4 qt · 148.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Landini 7800 (DT) sources
- Source: Traktorenlexikon, “Landini 7800 DT”
- Source: Traktorenlexikon, “Massey Ferguson MF 373”
SAME Centauro 70 (DT) sources
- Source: Traktorenlexikon, “SAME Centauro 70 (DT)”