8 material differences · fewer than 12
Tractor oneLandini R-7500 (DT)1978–1987No measured PTO figureTractor twoSteyr 8080 (a)1979–1992No measured PTO figure
Which should you choose?
Read our verdict on the R-7500 (DT) and the 8080 (a) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | R-7500 (DT) | 8080 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | Perkins LD.22756 (A 4.236) | Steyr WD-411.86 or WD-411.85 | differs |
| Displacement declared | 3.87 L | 3.46 L | +12% R-7500 (DT) |
| Maximum torque declared | 198 lb·ft · 268 N·m | 189 lb·ft · 256 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5–24.9 mph · 25–40 km/h | differs |
| Clutch declared | Dry LUK double clutch, pedal-operated driving clutch and hand lever-operated PTO clutch | — | — |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,896 lb · 3,128 kg | 6,191 lb · 2,808 kg | +11% R-7500 (DT) |
| Wheelbase declared | 96.9 in · 2,460 mm | 86.4 in · 2,195 mm | +12% R-7500 (DT) |
| Length declared | 150.8 in · 3,830 mm | 148.4 in · 3,770 mm | — |
| Width declared | 77.6 in · 1,970 mm | 74.1–91.7 in · 1,883–2,330 mm | differs |
| Ground clearance declared | 17.7 in · 450 mm | 15.7 in · 400 mm | +13% R-7500 (DT) |
| Turning radius, braked declared | 11.2 ft · 3.42 m | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 64.5 qt · 61.0 L | 101.4 qt · 96.0 L | +57% 8080 (a) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Landini R-7500 (DT) sources
- Source: Traktorenlexikon, “Landini 7550”
Steyr 8080 (a) sources
- Source: Traktorenlexikon, “Steyr 8080”