Landini 6830 (DT) TL-21 N/L (TL-21 DT/M) or Steyr 8075 (a)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 6830 (DT) TL-21 N/L (TL-21 DT/M) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8075 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Steyr 8075 (a) suits loader and hydraulic implement work better on this data: 29% (590 kg / 1,301 lb) more three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Landini 6830 (DT) TL-21 N/L (TL-21 DT/M) and Steyr 8075 (a), with the call on each
Question6830 (DT) TL-21 N/L (TL-21 DT/M)8075 (a)Call
Which puts more power through the PTO shaft?47.8 kW (64.1 hp)Traktorenlexikon, “Landini 6830 (DT)”47.1 kW (63.2 hp)Traktorenlexikon, “Steyr 8075”Not comparableNot comparable on power at the PTO shaft: the 6830 (DT) TL-21 N/L (TL-21 DT/M) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8075 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 6830 (DT) TL-21 N/L (TL-21 DT/M) and the 8075 (a).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 6830 (DT) TL-21 N/L (TL-21 DT/M) and the 8075 (a).
Which pumps more oil for implements?37.1 L/min (9.8 gpm)Traktorenlexikon, “Landini 6830 (DT)”40.5 L/min (10.7 gpm)Traktorenlexikon, “Steyr 8075”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?2,010 kg (4,431 lb)Traktorenlexikon, “Landini 6830 (DT)”2,600 kg (5,732 lb)Traktorenlexikon, “Steyr 8075”AheadThe Steyr 8075 (a) has 29% more lift (590 kg / 1,301 lb) than the Landini 6830 (DT) TL-21 N/L (TL-21 DT/M) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?2,340 kg (5,159 lb)Traktorenlexikon, “Landini 6830 (DT)”2,600 kg (5,732 lb)Traktorenlexikon, “Steyr 8075”Ahead (a fact, not an advantage)The Steyr 8075 (a) is 11% heavier (260 kg / 573 lb) than the Landini 6830 (DT) TL-21 N/L (TL-21 DT/M) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 6830 (DT) TL-21 N/L (TL-21 DT/M) and the 8075 (a).
Which has the wider choice of gears?12Traktorenlexikon, “Landini 6830 (DT)”8 to 16Traktorenlexikon, “Steyr 8075”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 6830 (DT) TL-21 N/L (TL-21 DT/M) and the 8075 (a).
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Landini 6830 (DT)”25 km/h (15.5 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 8075”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Landini 6830 (DT)”540/1000 rpmTraktorenlexikon, “Steyr 8075”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?No figureNo call on PTO independence: not stated for the 6830 (DT) TL-21 N/L (TL-21 DT/M) and the 8075 (a).
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Landini 6830 (DT)”2WD / 4WDTraktorenlexikon, “Steyr 8075”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1983–19871983–1993EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Steyr 8075 (a) has 29% more lift (590 kg / 1,301 lb) than the Landini 6830 (DT) TL-21 N/L (TL-21 DT/M) (both lift at the hitch ends, as stated by the source).
  • The Steyr 8075 (a) is 11% heavier (260 kg / 573 lb) than the Landini 6830 (DT) TL-21 N/L (TL-21 DT/M) (both unladen weight, as stated by the source).
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 6830 (DT) TL-21 N/L (TL-21 DT/M) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 8075 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources