Landini R-5500 (DT) "TL 22 N/A" or Steyr 8060 (a)?
Which should you choose?
On performance, every comparable figure that differs favours the Landini R-5500 (DT) "TL 22 N/A": hydraulic flow. On features, the Steyr 8060 (a) is ahead on forward gears and top speed.
- The Landini R-5500 (DT) "TL 22 N/A" suits loader and hydraulic implement work better on this data: 19% (4.5 L/min / 1.2 gpm) more hydraulic flow.
- The Steyr 8060 (a) suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | R-5500 (DT) "TL 22 N/A" | 8060 (a) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 31.0 kW (41.6 hp)Traktorenlexikon, “Landini 5500” | 30.8 kW (41.3 hp)Traktorenlexikon, “Steyr 8060” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the R-5500 (DT) "TL 22 N/A" and the 8060 (a). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the R-5500 (DT) "TL 22 N/A" and the 8060 (a). |
| Which pumps more oil for implements? | 28.6 L/min (7.6 gpm)Traktorenlexikon, “Landini 5500” | 24.1 L/min (6.4 gpm)Traktorenlexikon, “Steyr 8060” | AheadThe Landini R-5500 (DT) "TL 22 N/A" has 19% more hydraulic flow (4.5 L/min / 1.2 gpm) than the Steyr 8060 (a) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,050 kg (4,519 lb)Traktorenlexikon, “Landini 5500” | 2,200 kg (4,850 lb)Traktorenlexikon, “Steyr 8060” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 2,010 kg (4,431 lb)Traktorenlexikon, “Landini 5500” | 2,420 kg (5,335 lb)Traktorenlexikon, “Steyr 8060” | Ahead (a fact, not an advantage)The Steyr 8060 (a) is 20% heavier (410 kg / 904 lb) than the Landini R-5500 (DT) "TL 22 N/A" (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the R-5500 (DT) "TL 22 N/A" and the 8060 (a). |
| Which has the wider choice of gears? | 12Traktorenlexikon, “Landini 5500” | 16Traktorenlexikon, “Steyr 8060” | AheadThe Steyr 8060 (a) has 33% more forward gears (4 gears) than the Landini R-5500 (DT) "TL 22 N/A" (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the R-5500 (DT) "TL 22 N/A" and the 8060 (a). |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “Landini 5500” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 8060” | AheadThe Steyr 8060 (a) has 20% more top speed (5.0 km/h / 3.1 mph) than the Landini R-5500 (DT) "TL 22 N/A" (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Landini 5500” | 540/1000 rpmTraktorenlexikon, “Steyr 8060” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the R-5500 (DT) "TL 22 N/A" and the 8060 (a). |
| Which drives on both axles? | 2WD / 4WDTraktorenlexikon, “Landini 5500” | 2WD / 4WDTraktorenlexikon, “Steyr 8060” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1973–1983 | 1979–1992 | Ahead (a fact, not an advantage)The Steyr 8060 (a) is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Landini R-5500 (DT) "TL 22 N/A" has 19% more hydraulic flow (4.5 L/min / 1.2 gpm) than the Steyr 8060 (a) (both pump flow, as stated by the source).
- The Steyr 8060 (a) is 20% heavier (410 kg / 904 lb) than the Landini R-5500 (DT) "TL 22 N/A" (both unladen weight, as stated by the source).
- The Steyr 8060 (a) has 33% more forward gears (4 gears) than the Landini R-5500 (DT) "TL 22 N/A" (both forward gears, as stated by the source).
- The Steyr 8060 (a) has 20% more top speed (5.0 km/h / 3.1 mph) than the Landini R-5500 (DT) "TL 22 N/A" (both top speed forward, as stated by the source).
- The Steyr 8060 (a) is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources