7 material differences · fewer than 12
Tractor oneLamborghini R-485 (DT)1971–1973No measured PTO figureTractor twoSOMECA 880 (TD)1975–1980No measured PTO figure
Which should you choose?
Read our verdict on the R-485 (DT) and the 880 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | R-485 (DT) | 880 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 82 hp | 86.8 hp | +6% 880 (TD) |
| Engine declared | LAMBORGHINI FL-1154 | O.M.-FIAT CO-3/75 | differs |
| Displacement declared | 4.99 L | 4.56 L | +9% R-485 (DT) |
| Maximum torque declared | 206 lb·ft · 279 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Pedal-operated dry WALTERSCHEID double clutch | Dry FERODO or LuK double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.4 gpm · 24.2 L/min | 7.1 gpm · 27.0 L/min | +12% 880 (TD) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 6,669 lb · 3,025 kg | 6,493 lb · 2,945 kg | — |
| Maximum permissible mass declared | — | 12,897 lb · 5,850 kg | — |
| Wheelbase declared | 89.0 in · 2,260 mm | 96.7 in · 2,457 mm | +9% 880 (TD) |
| Length declared | 149.2 in · 3,790 mm | 155.4 in · 3,946 mm | — |
| Width declared | 68.9–96.5 in · 1,750–2,450 mm | 77.6–105.1 in · 1,970–2,670 mm | differs |
| Ground clearance declared | — | 18.9 in · 480 mm | — |
| Turning radius, braked declared | 11.9 ft · 3.62 m | 12.4 ft · 3.79 m | — |
| Fuel tank declared | 68.7 qt · 65.0 L | 122.6 qt · 116.0 L | +78% 880 (TD) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Lamborghini R-485 (DT) sources
- Source: Traktorenlexikon, “Lamborghini R 485 (DT)”
- Source: Traktorenlexikon, “Lamborghini R 480 (DT)”
SOMECA 880 (TD) sources
- Source: Traktorenlexikon, “Someca 880”
- Source: Traktorenlexikon, “Fiat 880/880 DT”