13 material differences
Tractor oneLamborghini 450 DT1992–2003No measured PTO figureTractor twoNew Holland 3435 (A)1996–1999No measured PTO figure
Which should you choose?
Read our verdict on the 450 DT and the 3435 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
13 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 450 DT | 3435 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.4 hp | 44.4 hp | — |
| Engine declared | MITSUBISHI K 4 F-DT | IVECO 8035.06 | differs |
| Displacement declared | 1.49 L | 2.71 L | +82% 3435 (A) |
| Maximum torque declared | 74 lb·ft · 100.2 N·m | 107 lb·ft · 144.6 N·m | +44% 3435 (A) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 1.9 gpm · 7.1 L/min | 9.1 gpm · 34.5 L/min | +386% 3435 (A) |
| Pressure declared | — | 3,118 psi · 215 bar | — |
| Three-point lift, at the coupling points declared | 2,646 lb · 1,200 kg | 4,685 lb · 2,125 kg | +77% 3435 (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,535–2,690 lb · 1,150–1,220 kg | 4,321 lb · 1,960 kg | differs |
| Maximum permissible mass declared | 5,291 lb · 2,400 kg | 8,488 lb · 3,850 kg | +60% 3435 (A) |
| Wheelbase declared | 66.9 in · 1,700 mm | 78.7 in · 1,999 mm | +18% 3435 (A) |
| Length declared | 119.3 in · 3,030 mm | 127.6 in · 3,240 mm | +7% 3435 (A) |
| Width declared | 49.6–53.5 in · 1,260–1,360 mm | 60.6–84.3 in · 1,540–2,140 mm | differs |
| Ground clearance declared | 15.0 in · 380 mm | 14.8 in · 375 mm | — |
| Turning radius, braked declared | 10.8 ft · 3.30 m | — | — |
| Fuel tank declared | 30.6 qt · 29.0 L | 44.4 qt · 42.0 L | +45% 3435 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Lamborghini 450 DT sources
Source
- Source: Traktorenlexikon, “Lamborghini Runner 450 DT A”
New Holland 3435 (A) sources
Source
- Source: Traktorenlexikon, “New Holland 3435”