7 material differences · fewer than 12

Tractor oneJohn Deere 601952–1957No measured PTO figureTractor twoVALMET 33 D1957–1959No measured PTO figure

Which should you choose?

Read our verdict on the 60 and the 33 D → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

7 material differences · 2 fields identical or within 5%, which is not counted as material

John Deere 60 and VALMET 33 D, field by field
Field	60	33 D	Gap
Engine
Engine power, claimed claimed	36.9 hp	36.5 hp	—
Engine declared	—	VALMET 309 D	—
Displacement declared	—	2.69 L	—
Transmission
Top speed declared	11.0 mph · 17.7 km/h	18.6 mph · 30 km/h	+69% 33 D
Clutch declared	Pedal-operated dry single-plate clutch	Pedal-operated dry single-plate clutch	—
Hydraulics & hitch
Pump flow declared	8.9 gpm · 33.7 L/min	3.7 gpm · 14.0 L/min	+141% 60
Rear PTO speeds declared	536 rpm	540 rpm	differs
Weight & dimensions
Unladen weight declared	5,908 lb · 2,680 kg	3,715 lb · 1,685 kg	+59% 60
Wheelbase declared	90.0 in · 2,286 mm	74.8 in · 1,900 mm	+20% 60
Length declared	139.0 in · 3,531 mm	115.9 in · 2,945 mm	+20% 60
Width declared	86.6 in · 2,200 mm	67.7 in · 1,720 mm	+28% 60
Ground clearance declared	—	19.9 in · 505 mm	—
Turning radius, braked declared	—	10.7 ft · 3.25 m	—
Fuel tank declared	—	39.1 qt · 37.0 L	—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

John Deere 60 sources

Source

Source: Traktorenlexikon, “John Deere Modell 60”

VALMET 33 D sources