12 material differences
Tractor oneJohn Deere 9201967–1975No measured PTO figureTractor twoVALMET 33 D1957–1959No measured PTO figure
Which should you choose?
Read our verdict on the 920 and the 33 D → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 920 | 33 D | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 36.5 hp | 36.5 hp | — |
| Engine declared | John Deere M 4 FL 9 or 3.152 DL-02 | VALMET 309 D | differs |
| Displacement declared | 2.49 L | 2.69 L | +8% 33 D |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Pedal operated dry Fichtel & Sachs single disc clutch | Pedal-operated dry single-plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.9 gpm · 26 L/min | 3.7 gpm · 14.0 L/min | +86% 920 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,740 lb · 2,150 kg | 3,715 lb · 1,685 kg | +28% 920 |
| Maximum permissible mass declared | 7,055 lb · 3,200 kg | — | — |
| Wheelbase declared | 74.4 in · 1,890 mm | 74.8 in · 1,900 mm | — |
| Length declared | 134.8 in · 3,425 mm | 115.9 in · 2,945 mm | +16% 920 |
| Width declared | 59.1–85.0 in · 1,500–2,160 mm | 67.7 in · 1,720 mm | differs |
| Ground clearance declared | 15.7 in · 400 mm | 19.9 in · 505 mm | +26% 33 D |
| Turning radius, braked declared | 9.2 ft · 2.80 m | 10.7 ft · 3.25 m | +16% 33 D |
| Fuel tank declared | 66.0 qt · 62.5 L | 39.1 qt · 37.0 L | +69% 920 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 920 sources
Source
- Source: Traktorenlexikon, “John Deere 920”
VALMET 33 D sources
Source
- Source: Traktorenlexikon, “Valmet 33 D”