10 material differences · fewer than 12

Tractor oneJohn Deere 84101999–2002No measured PTO figureTractor twoSchlüter Super Trac 3000 TVL-LS1988–1989No measured PTO figure

Which should you choose?

We will not advise between these two machines, because they were not built in overlapping years (1999–2002; 1988–1989). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

10 material differences · 3 fields identical or within 5%, which is not counted as material

John Deere 8410 and Schlüter Super Trac 3000 TVL-LS, field by field
Field8410Super Trac 3000 TVL-LSGap
Engine
Engine power, claimed claimed266.5 hp276 hp—
Engine declaredJohn Deere-PowerTech 6.081 HRW-17MAN D 2566 MTEdiffers
Displacement declared8.13 L11.41 L+40% Super Trac 3000 TVL-LS
Maximum torque declared829 lb·ft · 1,124 N·m841 lb·ft · 1,140 N·m—
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h21.4 mph · 34.5 km/hdiffers
Clutch declaredPedal operated hydraulic wet John Deere multi-plate clutch——
Hydraulics & hitch
Hydraulic centre declaredClosed centre——
Hydraulic control declaredLoad sensing——
Pump flow declared31.8 gpm · 120.4 L/min14.0 gpm · 53.0 L/min+127% 8410
Pressure declared3,379 psi · 233 bar2,611 psi · 180 bar+29% 8410
Rear PTO speeds declared540/1000 rpm1000 rpmdiffers
Weight & dimensions
Unladen weight declared20,439 lb · 9,271 kg21,385–23,810 lb · 9,700–10,800 kgdiffers
Maximum permissible mass declared30,865 lb · 14,000 kg——
Wheelbase declared116.1 in · 2,950 mm116.1 in · 2,950 mm—
Length declared216.0 in · 5,487 mm234.3–239.4 in · 5,950–6,080 mmdiffers
Width declared118.6–129.3 in · 3,012–3,283 mm98.4–103.1 in · 2,500–2,620 mmdiffers
Ground clearance declared15.9 in · 405 mm——
Turning radius, braked declared—21.3 ft · 6.50 m—
Fuel tank declared540.0 qt · 511.0 L454.4 qt · 430 L+19% 8410

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

John Deere 8410 sources

Source
  • Source: Traktorenlexikon, “John Deere 8410”
  • Source: OECD test report 1936, 2000

Schlüter Super Trac 3000 TVL-LS sources

Source
  • Source: Traktorenlexikon, “Schlüter Super Trac 3000 TVL-LS”
  • Source: Traktorenlexikon, “Fendt Favorit 626 LS/LSA”