12 material differences
Tractor oneJohn Deere 5101964–1969No measured PTO figureTractor twoSOMECA DA-50 L1955–1957No measured PTO figure
Which should you choose?
Read our verdict on the 510 and the DA-50 L → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 510 | DA-50 L | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 39.4 hp | 38.5 hp | — |
| Engine declared | John Deere 152 D 22 L | O.M.-MILANO COD-40 | differs |
| Displacement declared | 2.49 L | 3.77 L | +51% DA-50 L |
| Maximum torque declared | 101 lb·ft · 137 N·m | 137 lb·ft · 186 N·m | +36% DA-50 L |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 13.7 mph · 22 km/h | differs |
| Clutch declared | Two-stage, pedal-operated, dry Fichtel & Sachs double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.1 gpm · 15.6 L/min | 3.4 gpm · 13.0 L/min | +20% 510 |
| Pressure declared | 2,190 psi · 151 bar | 1,784 psi · 123 bar | +23% 510 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,572 lb · 2,074 kg | 4,910 lb · 2,227 kg | +7% DA-50 L |
| Maximum permissible mass declared | 7,319 lb · 3,320 kg | — | — |
| Wheelbase declared | 81.6 in · 2,072 mm | 79.9 in · 2,030 mm | — |
| Length declared | 133.9 in · 3,400 mm | 130.3 in · 3,310 mm | — |
| Width declared | 62.2 in · 1,580 mm | 68.7–95.1 in · 1,745–2,415 mm | differs |
| Ground clearance declared | 17.5 in · 445 mm | 14.3 in · 364 mm | +22% 510 |
| Turning radius, braked declared | 10.0 ft · 3.05 m | 5.2 ft · 1.57 m | +94% 510 |
| Fuel tank declared | 74.0 qt · 70 L | 59.2 qt · 56.0 L | +25% 510 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 510 sources
Source
- Source: Traktorenlexikon, “John Deere 510”
SOMECA DA-50 L sources
Source
- Source: Traktorenlexikon, “Someca DA 50 L”
- Source: Traktorenlexikon, “Someca DA 50”