10 material differences · fewer than 12
Tractor oneJohn Deere 30201964–1972No measured PTO figureTractor twoRenault 751-41973–1980No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; 4WD); they were not built in overlapping years (1964–1972; 1973–1980). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 3020 | 751-4 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74.0 hp | 74.0 hp | — |
| Engine declared | John Deere 13 E | MWM D 226-4 | differs |
| Displacement declared | 4.43 L | 4.15 L | +7% 3020 |
| Maximum torque declared | 186 lb·ft · 252 N·m | 188 lb·ft · 255 N·m | — |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | Pedal-operated dry single-disc clutch | Dry LuK double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 18.0 gpm · 68.0 L/min | 8.7 gpm · 33.0 L/min | +106% 3020 |
| Pressure declared | — | 2,321 psi · 160 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,553 lb · 3,426 kg | 7,529 lb · 3,415 kg | — |
| Maximum permissible mass declared | 11,067 lb · 5,020 kg | — | — |
| Wheelbase declared | 90.0 in · 2,286 mm | 95.7 in · 2,430 mm | +6% 751-4 |
| Length declared | 138.5 in · 3,518 mm | 162.6 in · 4,130 mm | +17% 751-4 |
| Width declared | 89.6 in · 2,276 mm | 76.4–97.6 in · 1,940–2,480 mm | differs |
| Ground clearance declared | 15.6 in · 395 mm | 15.4 in · 390 mm | — |
| Turning radius, braked declared | — | 16.6 ft · 5.05 m | — |
| Fuel tank declared | 116.0 qt · 109.8 L | 86.6 qt · 82.0 L | +34% 3020 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 3020 sources
- Source: Traktorenlexikon, “John Deere 3020”
Renault 751-4 sources
- Source: Traktorenlexikon, “Renault 751-4 R7624”
- Source: Traktorenlexikon, “Fendt Farmer 108 S/SA”
- Source: Traktorenlexikon, “Renault 751-4S R7504”