8 material differences · fewer than 12
Tractor oneJohn Deere 2555 (A)1984–1992No measured PTO figureTractor twoSAME Saturno 80 (DT)1972–1980No measured PTO figure
Which should you choose?
Read our verdict on the 2555 (A) and the Saturno 80 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 2555 (A) | Saturno 80 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 76.0 hp | 75.9 hp | — |
| Engine declared | John Deere 4.239 DL-008 or TL-006 | SAME DA 039-1054 L or 1054 P | differs |
| Displacement declared | 3.92 L | 4.15 L | +6% Saturno 80 (DT) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Pedal-operated dry LuK single-disc clutch | Pedal-operated dry two-stage SAME double clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pressure declared | 3,336 psi · 230 bar | — | — |
| Three-point lift, at the coupling points declared | 3,371 lb · 1,529 kg | 4,806 lb · 2,180 kg | +43% Saturno 80 (DT) |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,110 lb · 3,225 kg | 6,085 lb · 2,760 kg | +17% 2555 (A) |
| Wheelbase declared | 89.7 in · 2,279 mm | 92.5 in · 2,350 mm | — |
| Length declared | 145.0 in · 3,683 mm | 143.7 in · 3,650 mm | — |
| Width declared | 89.4 in · 2,270 mm | 76.0–95.7 in · 1,930–2,430 mm | differs |
| Ground clearance declared | 16.1 in · 410 mm | 19.7 in · 500 mm | +22% Saturno 80 (DT) |
| Turning radius, braked declared | — | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 88.8 qt · 84.0 L | 84.5 qt · 80.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 2555 (A) sources
- Source: Traktorenlexikon, “John Deere 2555”
SAME Saturno 80 (DT) sources
- Source: Traktorenlexikon, “SAME Saturno 80 Synchro”