8 material differences · fewer than 12

Tractor oneJohn Deere 2155 (A)1987–1992No measured PTO figureTractor twoSAME Explorer 55 (DT)1983–1986No measured PTO figure

Which should you choose?

We will not advise between these two machines, because they were not built in overlapping years (1987–1992; 1983–1986). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

8 material differences · 5 fields identical or within 5%, which is not counted as material

John Deere 2155 (A) and SAME Explorer 55 (DT), field by field
Field2155 (A)Explorer 55 (DT)Gap
Engine
Engine power, claimed claimed54.3 hp54.3 hp—
Engine declaredJohn Deere 3.179 DL-017 or DL-001SAME 916.3 Adiffers
Displacement declared2.94 L2.75 L+7% 2155 (A)
Maximum torque declared—131 lb·ft · 177 N·m—
Transmission
Top speed declared18.6 mph · 30 km/h18.6 mph · 30 km/h—
Clutch declaredPedal-operated dry Fichtel & Sachs single-disc clutch——
Hydraulics & hitch
Hydraulic centre declaredClosed centre——
Hydraulic control declared—Load sensing—
Pump flow declared14.0 gpm · 52.9 L/min7.7 gpm · 29.0 L/min+82% 2155 (A)
Pressure declared2,321 psi · 160 bar——
Three-point lift, at the coupling points declared3,616 lb · 1,640 kg5,004 lb · 2,270 kg+38% Explorer 55 (DT)
Rear PTO speeds declared540 rpm540 rpm—
Weight & dimensions
Unladen weight declared5,104 lb · 2,315 kg5,600 lb · 2,540 kg+10% Explorer 55 (DT)
Wheelbase declared74.4 in · 1,889 mm86.4 in · 2,195 mm+16% Explorer 55 (DT)
Length declared132.9 in · 3,375 mm138.6 in · 3,520 mm—
Width declared79.3 in · 2,015 mm72.0–95.6 in · 1,828–2,428 mmdiffers
Ground clearance declared14.4 in · 365 mm17.1 in · 435 mm+19% Explorer 55 (DT)
Turning radius, braked declared—11.0 ft · 3.35 m—
Fuel tank declared70.8 qt · 67.0 L70.8 qt · 67.0 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

John Deere 2155 (A) sources

Source
  • Source: Traktorenlexikon, “John Deere 2155”

SAME Explorer 55 (DT) sources

Source
  • Source: Traktorenlexikon, “SAME Explorer 55”