John Deere 2000 (A) or Lamborghini 450 DT?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 2000 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 450 DT has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The John Deere 2000 (A) suits loader and hydraulic implement work better on this data: 351% (24.9 L/min / 6.6 gpm) more hydraulic flow and 69% (830 kg / 1,830 lb) more three-point lift.
- The John Deere 2000 (A) suits road haulage better on this data: 129% (3,100 kg / 6,834 lb) more maximum permissible mass and 20% (5.0 km/h / 3.1 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 2000 (A) | 450 DT | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 33.1 kW (44.4 hp)Traktorenlexikon, “John Deere 2000” | 33.1 kW (44.4 hp)Traktorenlexikon, “Lamborghini Runner 450 DT A” | Not comparableNot comparable on power at the PTO shaft: the 2000 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 450 DT has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 2000 (A) and the 450 DT. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 2000 (A) and the 450 DT. |
| Which pumps more oil for implements? | 32.0 L/min (8.5 gpm)Traktorenlexikon, “John Deere 2000” | 7.1 L/min (1.9 gpm)Traktorenlexikon, “Lamborghini Runner 450 DT A” | AheadThe John Deere 2000 (A) has 351% more hydraulic flow (24.9 L/min / 6.6 gpm) than the Lamborghini 450 DT (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,030 kg (4,475 lb)Traktorenlexikon, “John Deere 2000” | 1,200 kg (2,646 lb)Traktorenlexikon, “Lamborghini Runner 450 DT A” | AheadThe John Deere 2000 (A) has 69% more lift (830 kg / 1,830 lb) than the Lamborghini 450 DT (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,895 kg (6,382 lb)Traktorenlexikon, “John Deere 2000” | 1,150 kg (2,535 lb) to 1,220 kg (2,690 lb)Traktorenlexikon, “Lamborghini Runner 450 DT A” | Ahead (a fact, not an advantage)The John Deere 2000 (A) is 137% heavier (1,675 kg / 3,693 lb) than the Lamborghini 450 DT (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | 5,500 kg (12,125 lb)Traktorenlexikon, “John Deere 2000” | 2,400 kg (5,291 lb)Traktorenlexikon, “Lamborghini Runner 450 DT A” | AheadThe John Deere 2000 (A) has 129% higher maximum permissible mass (3,100 kg / 6,834 lb) than the Lamborghini 450 DT (both maximum permissible mass, as stated by the source). |
| Which has the wider choice of gears? | 10Traktorenlexikon, “John Deere 2000” | 12Traktorenlexikon, “Lamborghini Runner 450 DT A” | EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 2000 (A) and the 450 DT. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “John Deere 2000” | 25 km/h (15.5 mph)Traktorenlexikon, “Lamborghini Runner 450 DT A” | AheadThe John Deere 2000 (A) has 20% more top speed (5.0 km/h / 3.1 mph) than the Lamborghini 450 DT (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “John Deere 2000” | 540/1000 rpmTraktorenlexikon, “Lamborghini Runner 450 DT A” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the 2000 (A) and the 450 DT. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “John Deere 2000” | 4WDTraktorenlexikon, “Lamborghini Runner 450 DT A” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1993–1996 | 1992–2003 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The John Deere 2000 (A) has 351% more hydraulic flow (24.9 L/min / 6.6 gpm) than the Lamborghini 450 DT (both pump flow, as stated by the source).
- The John Deere 2000 (A) has 69% more lift (830 kg / 1,830 lb) than the Lamborghini 450 DT (both lift at the hitch ends, as stated by the source).
- The John Deere 2000 (A) is 137% heavier (1,675 kg / 3,693 lb) than the Lamborghini 450 DT (both unladen weight, as stated by the source).
- The John Deere 2000 (A) has 129% higher maximum permissible mass (3,100 kg / 6,834 lb) than the Lamborghini 450 DT (both maximum permissible mass, as stated by the source).
- The John Deere 2000 (A) has 20% more top speed (5.0 km/h / 3.1 mph) than the Lamborghini 450 DT (both top speed forward, as stated by the source).
- Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 2000 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 450 DT has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources