11 material differences · fewer than 12
Tractor oneJohn Deere 1846 FA1996–2003No measured PTO figureTractor twoSteyr 8065 (a)1986–1992No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1996–2003; 1986–1992). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 1846 FA | 8065 (a) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 55.3 hp | 55.3 hp | — |
| Engine declared | John Deere 3029 DFG-22 | Steyr WD-311.87 or WD-311.85 | differs |
| Displacement declared | 2.94 L | 2.59 L | +13% 1846 FA |
| Maximum torque declared | 133 lb·ft · 181 N·m | 147 lb·ft · 199 N·m | +10% 8065 (a) |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 15.5–24.9 mph · 25–40 km/h | differs |
| Clutch declared | Pedal-operated dry LuK double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 6.9 gpm · 26.0 L/min | — | — |
| Pressure declared | 2,176 psi · 150 bar | 3,553 psi · 245 bar | +63% 8065 (a) |
| Rear PTO speeds declared | 540 rpm / 750 rpm / 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,519 lb · 2,050 kg | 5,368 lb · 2,435 kg | +19% 8065 (a) |
| Wheelbase declared | 75.3 in · 1,912 mm | 78.7 in · 1,998 mm | — |
| Length declared | 128.6 in · 3,267 mm | 137.6 in · 3,495 mm | +7% 8065 (a) |
| Width declared | 57.5 in · 1,460 mm | 67.8 in · 1,722 mm | +18% 8065 (a) |
| Ground clearance declared | 14.4 in · 365 mm | 16.9 in · 430 mm | +18% 8065 (a) |
| Turning radius, braked declared | — | 10.3 ft · 3.14 m | — |
| Fuel tank declared | 42.3 qt · 40.0 L | 63.4 qt · 60.0 L | +50% 8065 (a) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
John Deere 1846 FA sources
- Source: Traktorenlexikon, “John Deere 1846 F/A”
Steyr 8065 (a) sources
- Source: Traktorenlexikon, “Steyr 8065”