10 material differences · fewer than 12

Tractor oneJohn Deere 1846 FA1996–2003No measured PTO figureTractor twoSAME Dorado 55 (DT)2000–2004No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (27%); the drive differs (4WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

10 material differences · 3 fields identical or within 5%, which is not counted as material

John Deere 1846 FA and SAME Dorado 55 (DT), field by field
Field1846 FADorado 55 (DT)Gap
Engine
Engine power, claimed claimed55.3 hp55.3 hp—
Engine declaredJohn Deere 3029 DFG-22SAME-DEUTZ-FAHR 1000.3 A 5differs
Displacement declared2.94 L3.00 L—
Maximum torque declared133 lb·ft · 181 N·m145 lb·ft · 197 N·m+9% Dorado 55 (DT)
Transmission
Top speed declared24.9 mph · 40 km/h24.9 mph · 40 km/h—
Clutch declaredPedal-operated dry LuK double clutch——
Hydraulics & hitch
Hydraulic control declaredLoad sensing——
Pump flow declared6.9 gpm · 26.0 L/min——
Pressure declared2,176 psi · 150 bar3,118 psi · 215 bar+43% Dorado 55 (DT)
Rear PTO speeds declared540 rpm / 750 rpm / 1000 rpm540/540E/1000 rpmdiffers
Weight & dimensions
Unladen weight declared4,519 lb · 2,050 kg5,732 lb · 2,600 kg+27% Dorado 55 (DT)
Maximum permissible mass declared—11,023 lb · 5,000 kg—
Wheelbase declared75.3 in · 1,912 mm82.9 in · 2,105 mm+10% Dorado 55 (DT)
Length declared128.6 in · 3,267 mm145.7 in · 3,700 mm+13% Dorado 55 (DT)
Width declared57.5 in · 1,460 mm70.5–87.8 in · 1,790–2,230 mmdiffers
Ground clearance declared14.4 in · 365 mm17.5 in · 445 mm+22% Dorado 55 (DT)
Turning radius, braked declared—10.0 ft · 3.06 m—
Fuel tank declared42.3 qt · 40.0 L95.1 qt · 90.0 L+125% Dorado 55 (DT)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

John Deere 1846 FA sources

Source
  • Source: Traktorenlexikon, “John Deere 1846 F/A”

SAME Dorado 55 (DT) sources

Source
  • Source: Traktorenlexikon, “SAME Dorado 55”
  • Source: Traktorenlexikon, “SAME Dorado 60”