J.I. Case 930 or J.I. Case 931 GP?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for J.I. Case 930 and J.I. Case 931 GP, with the call on each
Question930931 GPCall
Which puts more power through the PTO shaft?61.8 kW (82.9 hp)Traktorenlexikon, “Case 930”61.8 kW (82.9 hp)Traktorenlexikon, “Case 931”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 930 and the 931 GP.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 930 and the 931 GP.
Which pumps more oil for implements?58.7 L/min (15.5 gpm)Traktorenlexikon, “Case 930”58.7 L/min (15.5 gpm)Traktorenlexikon, “Case 931”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?No figureNo call on three-point lift: no figure on record for the 930 and the 931 GP.
Which is heavier, for traction?3,970 kg (8,752 lb)Traktorenlexikon, “Case 930”4,044 kg (8,915 lb)Traktorenlexikon, “Case 931”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 930 and the 931 GP.
Which has the wider choice of gears?6 to 8Traktorenlexikon, “Case 930”6 to 8Traktorenlexikon, “Case 931”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 930 and the 931 GP.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Case 930”25 km/h (15.5 mph)Traktorenlexikon, “Case 931”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Case 930”540/1000 rpmTraktorenlexikon, “Case 931”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Case 930”independentTraktorenlexikon, “Case 931”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?2WDTraktorenlexikon, “Case 930”2WDTraktorenlexikon, “Case 931”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1962–19691959–1969EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • Even on drive: all two-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources