5 material differences · fewer than 12
Tractor oneJ.I. Case 48941984–1985No measured PTO figureTractor twoSchlüter Profi Trac 3500 TVL1978–1981No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1984–1985; 1978–1981). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 4894 | Profi Trac 3500 TVL | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 296.0 hp | 315 hp | +6% Profi Trac 3500 TVL |
| Engine declared | SAAB-SCANIA 11-L | MAN D 2566 MTE | differs |
| Displacement declared | 8.26 L | 11.41 L | +38% Profi Trac 3500 TVL |
| Maximum torque declared | 845 lb·ft · 1,146 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 21.3 mph · 34.3 km/h | +14% Profi Trac 3500 TVL |
| Clutch declared | Hydraulically operated wet disc clutch | Single-disc dry clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 24.0 gpm · 90.8 L/min | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 25,750 lb · 11,680 kg | 27,007 lb · 12,250 kg | — |
| Wheelbase declared | 110.0 in · 2,794 mm | 113.8 in · 2,890 mm | — |
| Length declared | 243.0 in · 6,172 mm | 242.1 in · 6,150 mm | — |
| Width declared | 99.0 in · 2,515 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 18.0 in · 457 mm | 19.7 in · 500 mm | +9% Profi Trac 3500 TVL |
| Turning radius, braked declared | — | 16.4 ft · 5.00 m | — |
| Fuel tank declared | — | 470.2 qt · 445 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
J.I. Case 4894 sources
- Source: Traktorenlexikon, “Case 4894”
- Source: Traktorenlexikon, “Case 4890”
Schlüter Profi Trac 3500 TVL sources
- Source: Traktorenlexikon, “Schlüter Profi Trac 3500 TVL”
- Source: Traktorenlexikon, “Fendt Favorit 626 LS/LSA”