8 material differences · fewer than 12
Tractor oneJ.I. Case 2394 (DT)1984–1985No measured PTO figureTractor twoSchlüter Super 1700 LS (high speed)1993No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; 4WD); they were not built in overlapping years (1984–1985; 1993–1993). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 2394 (DT) | Super 1700 LS (high speed) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 168.7 hp | 170.0 hp | — |
| Engine declared | CASE 504 BDT | MAN D0 826 LE 503 | differs |
| Displacement declared | 8.26 L | 6.87 L | +20% 2394 (DT) |
| Maximum torque declared | 487 lb·ft · 660 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | pedal operated wet disc clutch | — | — |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 1000 rpm | 674/1126 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 16,237 lb · 7,365 kg | 14,110 lb · 6,400 kg | +15% 2394 (DT) |
| Wheelbase declared | 118.0 in · 2,997 mm | 110.6 in · 2,810 mm | +7% 2394 (DT) |
| Length declared | 175.5 in · 4,458 mm | 187.4 in · 4,760 mm | +7% Super 1700 LS (high speed) |
| Width declared | 96.0 in · 2,438 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 22.5 in · 572 mm | — | — |
| Turning radius, braked declared | 13.6 ft · 4.16 m | 15.4 ft · 4.70 m | +13% Super 1700 LS (high speed) |
| Fuel tank declared | 339.9 qt · 321.7 L | 327.6 qt · 310 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
J.I. Case 2394 (DT) sources
- Source: Traktorenlexikon, “Case 2394”
- Source: Traktorenlexikon, “Case 2290”
Schlüter Super 1700 LS (high speed) sources
- Source: Traktorenlexikon, “Schlüter Super 1700 LS / TVL-LS”
- Source: Traktorenlexikon, “Schlüter Super 1600 TVL /TVL-LS”