J.I. Case 1170 or J.I. Case 2294 (DT)?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for J.I. Case 1170 and J.I. Case 2294 (DT), with the call on each
Question11702294 (DT)Call
Which puts more power through the PTO shaft?88.1 kW (118.2 hp)Traktorenlexikon, “Case 1170”86.1 kW (115.5 hp)Traktorenlexikon, “Case 2294”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 1170 and the 2294 (DT).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 1170 and the 2294 (DT).
Which pumps more oil for implements?60.6 L/min (16.0 gpm)Traktorenlexikon, “Case 1170”No figureNo call on hydraulic flow: no figure on record for the 2294 (DT).
Which lifts more on the three-point hitch?4,535 kg (9,998 lb)Traktorenlexikon, “Case 2294”No figureNo call on three-point lift: no figure on record for the 1170.
Which is heavier, for traction?6,142 kg (13,541 lb)Traktorenlexikon, “Case 1170”6,527 kg (14,390 lb)Traktorenlexikon, “Case 2294”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 1170 and the 2294 (DT).
Which has the wider choice of gears?8 to 12Traktorenlexikon, “Case 1170”12Traktorenlexikon, “Case 2294”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 1170 and the 2294 (DT).
Which is faster on the road?25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Case 1170”30 km/h (18.6 mph)Traktorenlexikon, “Case 2294”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Case 1170”540/1000 rpmTraktorenlexikon, “Case 2294”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Case 1170”independentTraktorenlexikon, “Case 2294”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?2WDTraktorenlexikon, “Case 1170”2WDTraktorenlexikon, “Case 2294”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1970–19721984–1985Ahead (a fact, not an advantage)The J.I. Case 2294 (DT) is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The J.I. Case 2294 (DT) is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • Even on drive: all two-wheel drive.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources