J.I. Case 1070 or SAME Tiger 100 (DT)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 1070 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Tiger 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The J.I. Case 1070 suits loader and hydraulic implement work better on this data: 73% (25.6 L/min / 6.8 gpm) more hydraulic flow.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 1070 | Tiger 100 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 75.1 kW (100.7 hp)Traktorenlexikon, “Case 1070” | 75 kW (101 hp)Traktorenlexikon, “SAME Tiger 100” | Not comparableNot comparable on power at the PTO shaft: the 1070 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Tiger 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 1070 and the Tiger 100 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 1070 and the Tiger 100 (DT). |
| Which pumps more oil for implements? | 60.6 L/min (16.0 gpm)Traktorenlexikon, “Case 1070” | 35.0 L/min (9.2 gpm)Traktorenlexikon, “SAME Tiger 100” | AheadThe J.I. Case 1070 has 73% more hydraulic flow (25.6 L/min / 6.8 gpm) than the SAME Tiger 100 (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | — | 2,940 kg (6,482 lb)Traktorenlexikon, “SAME Tiger 100” | No figureNo call on three-point lift: no figure on record for the 1070. |
| Which is heavier, for traction? | 4,677 kg (10,311 lb)Traktorenlexikon, “Case 1070” | 3,770 kg (8,311 lb)Traktorenlexikon, “SAME Tiger 100” | Ahead (a fact, not an advantage)The J.I. Case 1070 is 24% heavier (907 kg / 2,000 lb) than the SAME Tiger 100 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 1070 and the Tiger 100 (DT). |
| Which has the wider choice of gears? | 8 to 12Traktorenlexikon, “Case 1070” | 12 to 24Traktorenlexikon, “SAME Tiger 100” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 1070 and the Tiger 100 (DT). |
| Which is faster on the road? | 25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Case 1070” | 25 km/h (15.5 mph)Traktorenlexikon, “SAME Tiger 100” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Case 1070” | 540/1000 rpmTraktorenlexikon, “SAME Tiger 100” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Case 1070” | independentTraktorenlexikon, “SAME Tiger 100” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Case 1070” | Two-wheel or four-wheel driveTraktorenlexikon, “SAME Tiger 100” | AheadThe SAME Tiger 100 (DT) is available with four-wheel drive; the J.I. Case 1070 is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1969–1978 | 1977–1980 | Ahead (a fact, not an advantage)The SAME Tiger 100 (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The J.I. Case 1070 has 73% more hydraulic flow (25.6 L/min / 6.8 gpm) than the SAME Tiger 100 (DT) (both pump flow, as stated by the source).
- The J.I. Case 1070 is 24% heavier (907 kg / 2,000 lb) than the SAME Tiger 100 (DT) (both unladen weight, as stated by the source).
- The SAME Tiger 100 (DT) is available with four-wheel drive; the J.I. Case 1070 is two-wheel drive (as stated by the sources).
- The SAME Tiger 100 (DT) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Not comparable on power at the PTO shaft: the 1070 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Tiger 100 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources