11 material differences · fewer than 12
Tractor oneInternational Harvester 785 (A)1981–1990No measured PTO figureTractor twoSAME Corsaro 701972–1980No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1981–1990; 1972–1980). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 785 (A) | Corsaro 70 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 75.9 hp | 66.1 hp | +15% 785 (A) |
| Engine declared | INTERNATIONAL-HARVESTER D-246 | SAME DA 036-984 or 984 P | differs |
| Displacement declared | 4.03 L | 3.62 L | +11% 785 (A) |
| Maximum torque declared | 190 lb·ft · 258 N·m | 176 lb·ft · 239 N·m | +8% 785 (A) |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | Pedal-operated dry Laycock single-disc clutch | pedal-operated dry two-stage double clutch with coil springs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 6.2 gpm · 23.5 L/min | — |
| Pressure declared | 2,698 psi · 186 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,702 lb · 3,040 kg | 5,908 lb · 2,680 kg | +13% 785 (A) |
| Maximum permissible mass declared | — | 10,362 lb · 4,700 kg | — |
| Wheelbase declared | 88.2 in · 2,240 mm | 92.5 in · 2,350 mm | — |
| Length declared | 147.2 in · 3,740 mm | 152.0 in · 3,860 mm | — |
| Width declared | 75.6 in · 1,920 mm | 70.9 in · 1,800 mm | +7% 785 (A) |
| Ground clearance declared | 15.6 in · 396 mm | 14.6 in · 370 mm | +7% 785 (A) |
| Turning radius, braked declared | 11.5 ft · 3.51 m | 12.5 ft · 3.80 m | +8% Corsaro 70 |
| Fuel tank declared | 118.3 qt · 112.0 L | 63.4 qt · 60.0 L | +87% 785 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester 785 (A) sources
- Source: Traktorenlexikon, “IHC 785 (XL)”
- Source: Traktorenlexikon, “IHC 784”
SAME Corsaro 70 sources
- Source: Traktorenlexikon, “SAME Corsaro 70”
- Source: Traktorenlexikon, “SAME Corsaro 70 DT”