9 material differences · fewer than 12
Tractor oneInternational Harvester Farmall MD/MDV1941–1952No measured PTO figureTractor twoInternational Harvester 15-30 (22-36)1929–1934No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1941–1952; 1929–1934). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | Farmall MD/MDV | 15-30 (22-36) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34.5 hp | 35.5 hp | — |
| Engine declared | INTERNATIONAL HARVESTER D-248 | INTERNATIONAL HARVESTER 425 | differs |
| Displacement declared | 4.06 L | 6.97 L | +72% 15-30 (22-36) |
| Transmission | |||
| Top speed declared | 16.2 mph · 26 km/h | 3.7 mph · 6.0 km/h | +333% Farmall MD/MDV |
| Clutch declared | Pedal operated dry Rockford single plate clutch | Pedal operated single plate clutch | differs |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 537 rpm | 593 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,300 lb · 2,404 kg | 6,539 lb · 2,966 kg | +23% 15-30 (22-36) |
| Wheelbase declared | 90.2 in · 2,292 mm | 85.0 in · 2,159 mm | +6% Farmall MD/MDV |
| Length declared | 126.7 in · 3,219 mm | 137.0 in · 3,480 mm | +8% 15-30 (22-36) |
| Width declared | 84.0–100.0 in · 2,134–2,540 mm | 65.0 in · 1,651 mm | differs |
| Ground clearance declared | 25.5 in · 648 mm | — | — |
| Turning radius, braked declared | — | 8.2 ft · 2.51 m | — |
| Fuel tank declared | 84.0 qt · 79.5 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester Farmall MD/MDV sources
- Source: Traktorenlexikon, “Farmall Farmall-MD”
- Source: Traktorenlexikon, “McCormick Farmall-MD”
- Source: Traktorenlexikon, “IHC Farmall-MD”
International Harvester 15-30 (22-36) sources
- Source: Traktorenlexikon, “McCormick 15-30 (22-36)”
- Source: Traktorenlexikon, “IHC 15-30 (22-36)”