9 material differences · fewer than 12
Tractor oneInternational Harvester Farmall 856 (A)1967–1971No measured PTO figureTractor twoSAME Buffalo DT1968–1974No measured PTO figure
Which should you choose?
Read our verdict on the Farmall 856 (A) and the Buffalo DT → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Farmall 856 (A) | Buffalo DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 101 hp | 103.5 hp | — |
| Engine declared | INTERNATIONAL HARVESTER C-301 | SAME DA 1006-V | differs |
| Displacement declared | — | 5.66 L | — |
| Maximum torque declared | 326 lb·ft · 442 N·m | 280 lb·ft · 380 N·m | +16% Farmall 856 (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Farmall 856 (A) |
| Clutch declared | — | Pedal-operated dry SAME single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.0 gpm · 45.5 L/min | 7.9 gpm · 30.0 L/min | +52% Farmall 856 (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,501 lb · 3,856 kg | 9,524 lb · 4,320 kg | +12% Buffalo DT |
| Wheelbase declared | 101.0 in · 2,565 mm | 100.8 in · 2,560 mm | — |
| Length declared | 167.0 in · 4,242 mm | 157.5 in · 4,000 mm | +6% Farmall 856 (A) |
| Width declared | 92.0 in · 2,337 mm | 85.8 in · 2,180 mm | +7% Farmall 856 (A) |
| Ground clearance declared | 22.0 in · 559 mm | 17.3 in · 440 mm | +27% Farmall 856 (A) |
| Turning radius, braked declared | 9.5 ft · 2.90 m | 16.4 ft · 5.00 m | +72% Buffalo DT |
| Fuel tank declared | 168.0 qt · 159.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester Farmall 856 (A) sources
- Source: Traktorenlexikon, “Farmall Farmall 856”
- Source: Traktorenlexikon, “IHC 806”
SAME Buffalo DT sources
- Source: Traktorenlexikon, “SAME Buffalo”