9 material differences · fewer than 12
Tractor oneInternational Harvester Farmall 7561967–1971No measured PTO figureTractor twoSOMECA 880 (TD)1975–1980No measured PTO figure
Which should you choose?
Read our verdict on the Farmall 756 and the 880 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Farmall 756 | 880 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 75.0 hp | 86.8 hp | +16% 880 (TD) |
| Engine declared | INTERNATIONAL HARVESTER C-291 | O.M.-FIAT CO-3/75 | differs |
| Displacement declared | — | 4.56 L | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Farmall 756 |
| Clutch declared | Pedal operated dry single plate clutch | Dry FERODO or LuK double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 12.0 gpm · 45.5 L/min | 7.1 gpm · 27.0 L/min | +69% Farmall 756 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,699 lb · 3,946 kg | 6,493 lb · 2,945 kg | +34% Farmall 756 |
| Maximum permissible mass declared | — | 12,897 lb · 5,850 kg | — |
| Wheelbase declared | 97.5 in · 2,477 mm | 96.7 in · 2,457 mm | — |
| Length declared | 157.0 in · 3,988 mm | 155.4 in · 3,946 mm | — |
| Width declared | 92.0 in · 2,337 mm | 77.6–105.1 in · 1,970–2,670 mm | differs |
| Ground clearance declared | 21.0 in · 533 mm | 18.9 in · 480 mm | +11% Farmall 756 |
| Turning radius, braked declared | 9.2 ft · 2.82 m | 12.4 ft · 3.79 m | +34% 880 (TD) |
| Fuel tank declared | 132.1 qt · 125.0 L | 122.6 qt · 116.0 L | +8% Farmall 756 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester Farmall 756 sources
- Source: Traktorenlexikon, “Farmall Farmall 756”
SOMECA 880 (TD) sources
- Source: Traktorenlexikon, “Someca 880”
- Source: Traktorenlexikon, “Fiat 880/880 DT”