10 material differences · fewer than 12
Tractor oneInternational Harvester Farmall 5041961–1968No measured PTO figureTractor twoRenault Super 7D1965–1969No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (54%); the drive differs (2WD; 2WD / 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Farmall 504 | Super 7D | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 45.3 hp | 45 hp | — |
| Engine declared | INTERNATIONAL HARVESTER C-153 | — | — |
| Displacement declared | 2.49 L | — | — |
| Maximum torque declared | — | 115 lb·ft · 156 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% Farmall 504 |
| Clutch declared | Pedal operated dry single plate clutch | Two-stage pedal-operated dry FERODO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 12.0 gpm · 45.5 L/min | 4.8 gpm · 18.0 L/min | +153% Farmall 504 |
| Pressure declared | — | 2,277 psi · 157 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,386 lb · 2,443 kg | 3,505–4,101 lb · 1,590–1,860 kg | differs |
| Wheelbase declared | 89.0 in · 2,261 mm | 72.8–73.6 in · 1,850–1,870 mm | differs |
| Length declared | 132.8 in · 3,372 mm | 124.0–126.0 in · 3,150–3,200 mm | differs |
| Width declared | 83.0–96.5 in · 2,108–2,451 mm | 61.8–84.3 in · 1,570–2,140 mm | differs |
| Ground clearance declared | 23.3 in · 591 mm | 11.4–15.4 in · 290–390 mm | differs |
| Turning radius, braked declared | 8.2 ft · 2.50 m | 9.5 ft · 2.90 m | +16% Super 7D |
| Fuel tank declared | 90.0 qt · 85.2 L | 42.3 qt · 40.0 L | +113% Farmall 504 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester Farmall 504 sources
- Source: Traktorenlexikon, “Farmall Farmall 504”
- Source: Traktorenlexikon, “McCormick Farmall-H”
Renault Super 7D sources
- Source: Traktorenlexikon, “Renault Super 7D R7055”
- Source: Traktorenlexikon, “Renault Super 7 D/R 7055”