9 material differences · fewer than 12
Tractor oneInternational Harvester Farmall 3401958–1963No measured PTO figureTractor twoJohn Deere 11201967–1975No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1958–1963; 1967–1975). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
9 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Farmall 340 | 1120 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 39.4 hp | 48.4 hp | +23% 1120 |
| Engine declared | INTERNATIONAL HARVESTER C-135 | John Deere M 4 BL 4 or 3.164 DL-04 | differs |
| Displacement declared | 2.21 L | 2.70 L | +22% 1120 |
| Maximum torque declared | 128 lb·ft · 174 N·m | 119 lb·ft · 162 N·m | +7% Farmall 340 |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 12.4–15.5 mph · 20–25 km/h | differs |
| Clutch declared | Pedal operated dry Rockford single plate clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Pump flow declared | — | 6.0 gpm · 22.6 L/min | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,736 lb · 2,148 kg | 5,004 lb · 2,270 kg | +6% 1120 |
| Maximum permissible mass declared | — | 7,716 lb · 3,500 kg | — |
| Wheelbase declared | 80.2 in · 2,037 mm | 80.7 in · 2,050 mm | — |
| Length declared | 117.0 in · 2,972 mm | 135.0 in · 3,430 mm | +15% 1120 |
| Width declared | 64.0 in · 1,626 mm | 66.1–86.6 in · 1,680–2,200 mm | differs |
| Ground clearance declared | 20.0 in · 508 mm | 20.5 in · 521 mm | — |
| Turning radius, braked declared | — | 10.2 ft · 3.10 m | — |
| Fuel tank declared | 61.3 qt · 58.0 L | 66.0 qt · 62.5 L | +8% 1120 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester Farmall 340 sources
- Source: Traktorenlexikon, “IHC Farmall 340”
- Source: Traktorenlexikon, “IHC International 330”
- Source: Traktorenlexikon, “Farmall Farmall 340”
John Deere 1120 sources
- Source: Traktorenlexikon, “John Deere 1120”