7 material differences · fewer than 12
Tractor oneInternational Harvester Farmall 14681971–1974No measured PTO figureTractor twoInternational Harvester 10861976–1979No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1971–1974; 1976–1979). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Farmall 1468 | 1086 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 146.0 hp | 131.2 hp | +11% Farmall 1468 |
| Engine declared | INTERNATIONAL HARVESTER DV-8/550 | INTERNATIONAL HARVESTER DT-414 | differs |
| Displacement declared | 8.99 L | 6.78 L | +33% Farmall 1468 |
| Maximum torque declared | — | 391 lb·ft · 530 N·m | — |
| Transmission | |||
| Top speed declared | 21.7 mph · 35 km/h | 18.6 mph · 30 km/h | +17% Farmall 1468 |
| Clutch declared | Pedal operated ceramic clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.0 gpm · 45.5 L/min | 12.0 gpm · 45.4 L/min | — |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 13,459 lb · 6,105 kg | 12,725 lb · 5,772 kg | +6% Farmall 1468 |
| Wheelbase declared | 104.8 in · 2,662 mm | 104.8 in · 2,662 mm | — |
| Length declared | 168.0 in · 4,267 mm | 168.0 in · 4,267 mm | — |
| Width declared | 98.0 in · 2,489 mm | 102.0 in · 2,591 mm | — |
| Ground clearance declared | 16.0 in · 406 mm | 13.0 in · 330 mm | +23% Farmall 1468 |
| Turning radius, braked declared | 11.7 ft · 3.56 m | 11.6 ft · 3.53 m | — |
| Fuel tank declared | 168.0 qt · 159.0 L | 252.0 qt · 238.5 L | +50% 1086 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester Farmall 1468 sources
- Source: Traktorenlexikon, “Farmall Farmall 1468”
- Source: Traktorenlexikon, “IHC 1568”
- Source: Traktorenlexikon, “IHC 1468”
International Harvester 1086 sources
- Source: Traktorenlexikon, “IHC 1086”
- Source: Traktorenlexikon, “IHC 1066”