8 material differences · fewer than 12
Tractor oneInternational Harvester D-2191962–1966No measured PTO figureTractor twoMASSEY-HARRIS Pony 8201957–1961No measured PTO figure
Which should you choose?
Read our verdict on the D-219 and the Pony 820 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | D-219 | Pony 820 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 19 hp | 18.0 hp | — |
| Engine declared | INTERNATIONAL-HARVESTER DD-74 | HANOMAG D 621-E 54 | differs |
| Displacement declared | 1.22 L | 1.02 L | +19% D-219 |
| Maximum torque declared | — | 58 lb·ft · 78 N·m | — |
| Transmission | |||
| Top speed declared | 11.2 mph · 18 km/h | 9.3 mph · 15 km/h | +20% D-219 |
| Clutch declared | Pedal operated dry Fichtel & Sachs single disc clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.2 gpm · 19.5 L/min | 2.5 gpm · 9.5 L/min | +105% D-219 |
| Rear PTO speeds declared | 540 rpm | 534 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,802 lb · 1,271 kg | 2,315 lb · 1,050 kg | +21% D-219 |
| Maximum permissible mass declared | 4,299 lb · 1,950 kg | — | — |
| Wheelbase declared | 68.1 in · 1,730 mm | 67.3 in · 1,710 mm | — |
| Length declared | 105.2 in · 2,672 mm | 110.2 in · 2,800 mm | — |
| Width declared | 62.2 in · 1,581 mm | 56.0–80.0 in · 1,422–2,032 mm | differs |
| Ground clearance declared | 13.9 in · 354 mm | 18.5 in · 470 mm | +33% Pony 820 |
| Turning radius, braked declared | 8.0 ft · 2.45 m | — | — |
| Fuel tank declared | 28.5 qt · 27.0 L | 27.5 qt · 26.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester D-219 sources
- Source: Traktorenlexikon, “McCormick D-219”
- Source: Traktorenlexikon, “McCormick D-217 Farmall”
MASSEY-HARRIS Pony 820 sources
- Source: Traktorenlexikon, “Massey-Harris Massey-Harris Pony 820”