10 material differences · fewer than 12
Tractor oneInternational Harvester 444 USA1967–1971No measured PTO figureTractor twoJohn Deere 9201967–1975No measured PTO figure
Which should you choose?
Read our verdict on the 444 USA and the 920 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 444 USA | 920 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 36.3 hp | 36.5 hp | — |
| Engine declared | INTERNATIONAL HARVESTER C-153 | John Deere M 4 FL 9 or 3.152 DL-02 | differs |
| Displacement declared | 2.49 L | 2.49 L | — |
| Maximum torque declared | 113 lb·ft · 153 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 12.4–15.5 mph · 20–25 km/h | differs |
| Clutch declared | — | Pedal operated dry Fichtel & Sachs single disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.9 gpm · 22.5 L/min | 6.9 gpm · 26 L/min | +16% 920 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,070 lb · 1,846 kg | 4,740 lb · 2,150 kg | +16% 920 |
| Maximum permissible mass declared | — | 7,055 lb · 3,200 kg | — |
| Wheelbase declared | 70.0 in · 1,778 mm | 74.4 in · 1,890 mm | +6% 920 |
| Length declared | 121.0 in · 3,073 mm | 134.8 in · 3,425 mm | +11% 920 |
| Width declared | 65.0 in · 1,651 mm | 59.1–85.0 in · 1,500–2,160 mm | differs |
| Ground clearance declared | 17.0 in · 432 mm | 15.7 in · 400 mm | +8% 444 USA |
| Turning radius, braked declared | 8.2 ft · 2.49 m | 9.2 ft · 2.80 m | +12% 920 |
| Fuel tank declared | 56.0 qt · 53.0 L | 66.0 qt · 62.5 L | +18% 920 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
International Harvester 444 USA sources
- Source: Traktorenlexikon, “IHC 444 USA”
- Source: Traktorenlexikon, “McCormick Farmall-H”
John Deere 920 sources
- Source: Traktorenlexikon, “John Deere 920”