International Harvester 240 Utility or SOMECA 315?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 240 Utility has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 315 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The International Harvester 240 Utility suits loader and hydraulic implement work better on this data: 38% (6.3 L/min / 1.7 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for International Harvester 240 Utility and SOMECA 315, with the call on each
Question240 Utility315Call
Which puts more power through the PTO shaft?23.5 kW (31.5 hp)Traktorenlexikon, “IHC 240”24.3 kW (32.6 hp)Traktorenlexikon, “Someca 315”Not comparableNot comparable on power at the PTO shaft: the 240 Utility has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 315 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 240 Utility and the 315.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 240 Utility and the 315.
Which pumps more oil for implements?22.8 L/min (6.0 gpm)Traktorenlexikon, “IHC 240”16.5 L/min (4.4 gpm)Traktorenlexikon, “Someca 315”AheadThe International Harvester 240 Utility has 38% more hydraulic flow (6.3 L/min / 1.7 gpm) than the SOMECA 315 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?No figureNo call on three-point lift: no figure on record for the 240 Utility and the 315.
Which is heavier, for traction?1,650 kg (3,638 lb)Traktorenlexikon, “IHC 240”1,540 kg (3,395 lb)Traktorenlexikon, “Someca 315”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 240 Utility and the 315.
Which has the wider choice of gears?4Traktorenlexikon, “IHC 240”6 to 9Traktorenlexikon, “Someca 315”AheadThe SOMECA 315 has 50% more forward gears (2 gears) than the International Harvester 240 Utility (both forward gears, as stated by the source).
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 240 Utility and the 315.
Which is faster on the road?23 km/h (14.3 mph)Traktorenlexikon, “IHC 240”24 km/h (14.9 mph)Traktorenlexikon, “Someca 315”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “IHC 240”540 rpmTraktorenlexikon, “Someca 315”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?dependent (stops with the clutch)Traktorenlexikon, “IHC 240”independentTraktorenlexikon, “Someca 315”AheadThe SOMECA 315 has an independent PTO; the International Harvester 240 Utility’s is dependent (stops with the clutch).
Which drives on both axles?2WDTraktorenlexikon, “IHC 240”2WDTraktorenlexikon, “Someca 315”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1958–19611965–1968Ahead (a fact, not an advantage)The SOMECA 315 is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The International Harvester 240 Utility has 38% more hydraulic flow (6.3 L/min / 1.7 gpm) than the SOMECA 315 (both pump flow, as stated by the source).
  • The SOMECA 315 has 50% more forward gears (2 gears) than the International Harvester 240 Utility (both forward gears, as stated by the source).
  • The SOMECA 315 has an independent PTO; the International Harvester 240 Utility’s is dependent (stops with the clutch).
  • The SOMECA 315 is newer: production began 7 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on drive: all two-wheel drive.
  • Not comparable on power at the PTO shaft: the 240 Utility has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 315 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources