IMT 542 or UZINA TRACTORUL 420 (DT)?
Which should you choose?
On performance, every comparable figure that differs favours the IMT 542: hydraulic flow. It is also ahead on top speed. On features, the UZINA TRACTORUL 420 (DT) is ahead on drive.
- The IMT 542 suits loader and hydraulic implement work better on this data: 16% (2.5 L/min / 0.7 gpm) more hydraulic flow.
- The IMT 542 suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 542 | 420 (DT) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 24.7 kW (33.1 hp)Traktorenlexikon, “IMT 542” | 26.0 kW (34.9 hp)Traktorenlexikon, “UTB 420 (DT)” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 542 and the 420 (DT). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 542 and the 420 (DT). |
| Which pumps more oil for implements? | 18.5 L/min (4.9 gpm)Traktorenlexikon, “IMT 542” | 16.0 L/min (4.2 gpm)Traktorenlexikon, “UTB 420 (DT)” | AheadThe IMT 542 has 16% more hydraulic flow (2.5 L/min / 0.7 gpm) than the UZINA TRACTORUL 420 (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 1,407 kg (3,102 lb)Traktorenlexikon, “IMT 542” | — | No figureNo call on three-point lift: no figure on record for the 420 (DT). |
| Which is heavier, for traction? | 1,815 kg (4,001 lb)Traktorenlexikon, “IMT 542” | 1,640 kg (3,616 lb)Traktorenlexikon, “UTB 420 (DT)” | Ahead (a fact, not an advantage)The IMT 542 is 11% heavier (175 kg / 386 lb) than the UZINA TRACTORUL 420 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 542 and the 420 (DT). |
| Which has the wider choice of gears? | 6 to 10Traktorenlexikon, “IMT 542” | 6 to 9Traktorenlexikon, “UTB 420 (DT)” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 542 and the 420 (DT). |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “IMT 542” | 25 km/h (15.5 mph)Traktorenlexikon, “UTB 420 (DT)” | AheadThe IMT 542 has 20% more top speed (5.0 km/h / 3.1 mph) than the UZINA TRACTORUL 420 (DT) (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “IMT 542” | 540 rpmTraktorenlexikon, “UTB 420 (DT)” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “IMT 542” | independentTraktorenlexikon, “UTB 420 (DT)” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | 2WDTraktorenlexikon, “IMT 542” | Two-wheel or four-wheel driveTraktorenlexikon, “UTB 420 (DT)” | AheadThe UZINA TRACTORUL 420 (DT) is available with four-wheel drive; the IMT 542 is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1986– | 1974–1981 | Ahead (a fact, not an advantage)The IMT 542 is newer: production began 12 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The IMT 542 has 16% more hydraulic flow (2.5 L/min / 0.7 gpm) than the UZINA TRACTORUL 420 (DT) (both pump flow, as stated by the source).
- The IMT 542 is 11% heavier (175 kg / 386 lb) than the UZINA TRACTORUL 420 (DT) (both unladen weight, as stated by the source).
- The IMT 542 has 20% more top speed (5.0 km/h / 3.1 mph) than the UZINA TRACTORUL 420 (DT) (both top speed forward, as stated by the source).
- The UZINA TRACTORUL 420 (DT) is available with four-wheel drive; the IMT 542 is two-wheel drive (as stated by the sources).
- The IMT 542 is newer: production began 12 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540 rpm).
- Even on PTO independence: every PTO is independent.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources